Sensitive and Enzyme-Free Glucose Sensor Based on Copper Nanowires/Polyaniline/Reduced Graphene Oxide Nanocomposite Ink

Vijay Kumar Anand,Kapil Bhatt,Sandeep Kumar,B. Archana,Sandeep Sharma,Karamvir Singh,Monish Gupta,Rakesh Goyal,G. S. Virdi
DOI: https://doi.org/10.1142/S0219581X21500204
2021-03-11
International Journal of Nanoscience
Abstract:In this paper, we report the preparation and characterization of a sensitive and reusable nonenzymatic glucose (NEG) sensor based on copper nanowires (CuNWs)/polyaniline (PANI)/reduced graphene oxide (rGO) nanocomposite ink. The CuNWs/PANI/rGO nanocomposite ink was prepared by solvothermal mixing of CuNWs, PANI, rGO and binders. The X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM), Fourier Transform Infra-Red (FT-IR) spectroscopy techniques were used to assess the structural and morphological parameters of prepared nanocomposite ink. The cyclic voltammetry (CV) technique was used to estimate the electrochemical behavior of prepared NEG sensor. The structural, morphological and spectroscopy results confirmed the change in morphological and oxidation state of CuNWs to CuO nanostructures as a constituent of nanocomposite ink. The CuO nanostructures supported on PANI/rGO demonstrated good electrochemical stability and great electrocatalytic activity toward glucose oxidation. At a glucose oxidation potential of 0.64V, the prepared NEG sensor exhibited great electrocatalytic ability by offering a high sensitivity of 843.06 μ AmM −1 cm −2 in the linear glucose range 0–4mM with a lower detection limit of 1.6mM. In addition to these outstanding performance characteristics, CuNWs/PANI/rGO nanocomposite ink-based NEG sensor has the advantages of ease of fabrication, low cost and reusability.
What problem does this paper attempt to address?