Abstract:A critical component of long term geological sequestration of anthropogenic CO2 will be our ability to adequately monitor a chosen site to ensure public and environmental safety. Near surface monitoring is particularly important, as it is possible to conduct sensitive and direct measurements at the boundary between the subsurface and the biosphere (i.e. surface water or atmosphere). While discontinuous surface monitoring is often performed, continuous monitoring is preferable if one hopes to observe a leak in its early stages to allow for rapid remedial action. The geochemical signal that may result from a near-surface CO2 leak might take the form of increased soil gas concentrations (on land) or changing pH, Eh, and aqueous chemistry (in groundwater or surface water), and thus continuous monitoring stations capable of analyzing for these parameters have great potential for early leak detection. In the framework of the EC-funded CO2GeoNet and CO2ReMoVe projects innovative monitoring systems have been designed and constructed for autonomous deployment in marine environments above geological CO2 storage sites. The system developed within CO2GeoNet was tested at a site in the Gulf of Trieste where there is no gas release; this site was chosen due to easy access and the presence of an existing oceanographic buoy onto which the monitoring station was mounted. Tests on this early prototype highlighted the various difficulties of working in marine environments, and this experience formed the basis for a new system developed for deployment at the Panarea test site within CO2ReMoVe. This second site is located off the coast of Panarea Island, to the north of Sicily, where naturally-produced CO2 leaks from the seabed into the water column. The advantage of this site is that the leaks occur in a relatively near-shore environment (<300 m) and in water that is not too deep (<25 m), thereby allowing for easy access by SCUBA divers for system testing and maintenance. This location allowed the unit to be connected via cable, rather than a buoy, which makes power supply and data transfer simpler. The system developed for this site consists of three monitoring points that are connected to a land-based control unit. Each point, located 100, 200, and 300 m from shore in different CO2 flux regimes, is able to measure dissolved CO2 and CH4, conductivity, pH, and temperature using low cost but sensitive sensors. The complete system consists of flexible solar panels, a central control unit and three monitoring points, and data download is conducted using a GPRS connection and a web server. Difficulties with the initial deployment in early April of 2008 has necessitated further development work, with the second deployment planned for early November. The following paper discussed the experience gained with these stations, and presents data analysis and anomaly recognition from a land-based monitoring station that has been collecting dissolved CO2 data for over 18 months.

A Hybrid Lister‐Outrigger Probe for Rapid Marine Geothermal Gradient Measurement

Hydrothermal Organic Geochemistry (HOG) sampler for deployment on deep-sea submersibles

The “Little MonSta” Deep-Sea Benthic, Precision Deployable, Multi-Sensor and Sampling Lander Array

EarthScope-Oceans: an Array of Floating MERMAID Instruments for Earthquake Seismology

A Deep-Ocean Mass Spectrometer to Monitor Hydrocarbon Seeps and Pipelines

Half a cubic hectometer mooring array of 3000 temperature sensors in the deep sea

Passive Acoustic Glider for Seabed Characterization at the New England Mud Patch

Marine self-potential measurement tool for autonomous underwater vehicle

An instrument for sampling water from the benthic boundary layer

Development of an Underwater Adaptive Penetration System for In Situ Monitoring of Marine Engineering Geology

Sonarlogger: Enabling long-term underwater sonar observations

High-resolution Quasi-Distributed Temperature and Pressure Sensing System for Deep-Sea Reservoir Monitoring

A routine device for high resolution bottom water sampling

HALOBATES: An autonomous surface vehicle for high-resolution mapping of the sea-surface microlayer and near-surface layer on essential climate variables

Development on a New Type of Marine Plankton Temperature-Retained and Pressure-Retained Sampler

A quantitative, non-destructive methodology for habitat characterisation and benthic monitoring at offshore renewable energy developments

Development of an innovative marine monitoring system for CO2 leaks: system design and testing

Distributed Real-Time Plume Monitoring for Deep Sea Mineral Extraction

A Flux Detection Probe to Quantify Dynamic Groundwater‐Surface Water Exchange in the Hyporheic Zone

A Smart System for Environmental Parameter Monitoring in Underwater Archaeological Sites

Multi-Channel Data Logger Of In-Situ Chemical Sensors For Seafloor Hydrothermal Vents