Abstract:As the major power source for electric vehicles (EVs), lithium-ion batteries (LiBs) suffer from the degradation of technical performance and safety at low temperatures, which restricts the popularization of EVs in frigid regions. Thus, this study developed an extremely fast electromagnetic induction heating system in order to improve the poor performance of LiBs in cold weather. An electrochemical–thermal coupling model (ETCM), validated against the experimental results of charge and discharge, which successfully predicted LiB voltage, temperature, and other physical characteristics at various ambient temperatures, was established in COMSOL Multiphysics 6.0 as a development tool for evaluating the heating effect of the system. When the copper coil is subjected to a SAC (sinusoidal alternating current) of 8 A and 50 Hz, the LiB can be heated from 243.15 to 293.15 K within 6 min with an instantaneous temperature increase rate of 0.263 K/s and a homogeneous temperature distribution. The results of the capacity calibration, cyclable lithium detection, and HPPC simulation show that the heating method can visibly increase the Li+ concentration inside the active particle, and there was only a tiny concentration gradient on the surface of the particle. In addition, the internal resistance was approximately a quarter of that without heating; therefore, both the discharge energy and specific power boost were two times higher than the original level. Compared to the normal charge–discharge cycles at 293.15 K, the capacity retention of the LiB only decreased by 0.23% after 60 consecutive heating cycles, so the heating method can balance the temperature rise, work capacity, and LiB health. Furthermore, the improvements in the thermal insulation condition and material thermal conductivity are two feasible ways to optimize the temperature-increase effect.

Preheating Performance by Heating Film for the Safe Application of Cylindrical Lithium-ion Battery at Low Temperature

Combined film and pulse heating of lithium ion batteries to improve performance in low ambient temperature

Experimental study on self-heating strategy of lithium-ion battery at low temperatures based on bidirectional pulse current

A rapid self-heating strategy of lithium-ion battery at low temperatures based on bidirectional pulse current without external power

Experimental Study on Liquid Immersion Preheating of Lithium-Ion Batteries under Low Temperature Environment

Review of Low-Temperature Performance, Modeling and Heating for Lithium-Ion Batteries

Temperature consistency–oriented rapid heating strategy combining pulsed operation and external thermal management for lithium-ion batteries

Analysis of Low Temperature Preheating Effect Based on Battery Temperature-Rise Model

Numerical study of positive temperature coefficient heating on the lithium-ion battery at low temperature

Frequency varying heating strategy for lithium-ion battery rapid preheating under subzero temperature considering the limitation of on-board current

Investigation and Optimization of Fast Cold Start of 18650 Lithium-Ion Cell by Heating Film-Based Heating Method

Targeting the low-temperature performance degradation of lithium-ion batteries: a non-destructive bidirectional pulse current heating framework

Heat transfer characteristics and low-temperature performance of a lithium-ion battery with an inner cooling/heating structure

Thermoregulating Separators Based on Phase‐Change Materials for Safe Lithium‐Ion Batteries

Investigation of novel pulse preheating strategies for lithium-ion batteries at subzero temperature based on a multi-level CFD platform

Research on the Improvement of Lithium-Ion Battery Performance at Low Temperatures Based on Electromagnetic Induction Heating Technology

Effects of heating film and phase change material on preheating performance of the lithium-ion battery pack with large capacity under low temperature environment

Temperature Distribution of Lithium Ion Battery Module with Inconsistent Cells under Pulsed Heating Method

Fast internal preheating of 4680 lithium-ion batteries in cold environments

An optimal internal-heating strategy for lithium-ion batteries at low temperature considering both heating time and lifetime reduction

Optimal external heating resistance enabling rapid compound self-heating for lithium-ion batteries at low temperatures