Abstract:A synergistic modification strategy, combining the elemental doping, surface coating, and the creation of surface oxygen vacancies methods, is adopted to develop a high voltage lithium‐rich manganese oxides cathode. This synergistic modification can inhibit irreversible oxygen release under high‐voltage and improve the electrochemical properties and structural stability of this cathode. Even lithium‐rich manganese oxides (LRMOs) are considered as promising cathode materials for next‐generation lithium‐ion batteries, their commercialization is hindered mainly by the low initial Coulombic efficiency, poor cyclability and unexpected capacity fade. Here, a synergistic modification strategy by using both F doping and weak organic acid surface treatment is proposed to improve the electrochemical performances of LRMOs significantly. Optimized Li1.2Mn0.54Ni0.13Co0.13O1.95F0.05 sample with surface oxygen vacancy defects and thin carbon coating layer exhibits profound electrochemical performances, for example, discharging capacities of 298.6 and 212.5 mAh g−1 at 0.1 C and 1 C rate, respectively. In addition, it can own an initial Coulombic efficiency of 84.4%, which is much higher than that of untreated sample. In situ X‐ray diffraction analysis implies that synergistic modification can enhance the skeleton stability of LRMOs , especially at a high state of charge. Galvanostatic intermittent titration technique analysis suggests that as‐developed synergistic modification can accelerate the lithium ions diffusion. Theoretical calculations reveal that substituted F and oxygen vacancy defects can diminish the diffusion energy barrier of Li+ ions. This work provides a new synergistic modification strategy to improve the comprehensive properties of LRMO cathode effectively.

Enhancing Cyclic Performance of Lithium-rich Manganese-based Cathode via In-situ Co-doping of Magnesium and Fluorine

Mitigation of Cation Mixing of LiNiO2-based Cathode Materials by Li-doping for High-Performing Lithium-Ion Battery

Heightening the long cycling stability and reducing oxygen loss of Li-rich cathode materials by Mo–F Co-doping for half/full lithium-ion batteries

Suppressing Mn Reduction of Li-Rich Mn-Based Cathodes by F-Doping for Advanced Lithium-Ion Batteries

A cation/anion co-doped Li1.12Na0.08Ni0.2Mn0.6O1.95F0.05 cathode for lithium ion batteries

Enhanced Electrochemical Performance of the Lithium-Manganese-Rich Cathode for Li-Ion Batteries with Na and F CoDoping

Realizing High-Capacity and Low-Strain Manganese-Based Sodium Cathode by Regulating the Doping Sites of Mg with a Post-Doping Approach

A cation and anion dual-doping strategy in novel Li-rich Mn-based cathode materials for high-performance Li metal batteries

Synergistic Na+ and F− co-doping modification strategy to improve the electrochemical performance of Li-rich Li1·20Mn0·54Ni0·13Co0·13O2 cathode

Relieving capacity decay and voltage fading of Li1.2Ni0.13Co0.13Mn0.54O2 by Mg2+ and PO43- dual doping

Enhanced Performance of Li‐Rich Manganese Oxide Cathode Synergistically Modificated by F‐Doping and Oleic Acid Treatment

Enhancing the Power Capability of Lithium-Rich Manganese-Based Layered Oxide Cathodes by LaF3 Modification

Enhancing the Mn Redox Kinetics of LiMn0.5Fe0.5PO4 Cathodes Through a Synergistic Co-Doping with Niobium and Magnesium for Lithium-Ion Batteries

Surface Magnesium Substitution at Spinel Lithium Manganate 8a Tetrahedral Sites for Suppressed Manganese Dissolution and Enhanced Cycle Stability

Performance improvement of Li-rich Mn-based materials with the submicron-sized single-crystal morphology and cationic doping

Stabilizing the High-Voltage Cycle Performance of LiNi0.8Co0.1Mn0.1O2 Cathode Material by Mg Doping

A well-matched MgNiO 2 surface heterointerface layer to enhance the cycling stability of cobalt-free Li-rich Mn-based cathode materials

Regulating the internal structure by magnesium doping to enhance cycle stability of full-concentration-gradient Ni-rich layered cathodes

Modulating Surface Architecture and Electronic Conductivity of Li-rich Manganese-Based Cathode

Aluminum doping and lithium tungstate surface coating double effect to improve the cycle stability of lithium-rich manganese-based cathode materials

A novel modification strategy: Pulse electric current treatment optimizes the structure of lithium-rich manganese-based cathode materials to enhance electrochemical performance