Influence of the synthesis method on the morphology, dispersion and porosity of nanostructured powders of nickel–cobalt spinel NiCo2O4

D. I. Pereverzev,I. M. Giniyatullin,E. V. Vladimirova,V. D. Zhuravlev,A. V. Dmitriev
DOI: https://doi.org/10.1007/s10971-022-05850-9
2022-06-15
Abstract:The article discusses the results of the synthesis of spinel NiCo 2 O 4 by a new method of hydrothermolysis, as well as methods of precipitation of oxalates and ultrasonic aerosol pyrolysis from aqueous solutions of chlorides and nitrates of nickel and cobalt. The preparation conditions for each synthesis method were selected, the morphology of the obtained samples was considered, the porous structure of the material was studied, and the mesoporosity of the powders was estimated. Single-phase spinel NiCo 2 O 4 was obtained only by precipitation of oxalates; two other methods of synthesis, due to higher temperatures of the processes, lead to the appearance of an impurity of nickel–cobalt double oxide and a decrease in the nickel content in the spinel composition. The nature of the porosity of the materials obtained and the morphology depend on the synthesis method: the mesoporous structure in ultrasonic spray pyrolysis, macroporous structure in hydrothermolysis. The sample obtained by the oxalate precipitation method has the maximum specific surface area of 65.40 ± 0.33 m 2 /g and a pore volume of 0.409 cm 3 /g. The samples after hydrothermolysis have the minimum specific surface area of 10.22 ± 0.06 m 2 /g and a porosity of 0.055 cm 3 /g. The powders synthesized by ultrasonic spray pyrolysis have intermediate values of these characteristics between the other two methods, 41.68 ± 0.13 m 2 /g and 0.144 m 3 /g, respectively.
materials science, ceramics
What problem does this paper attempt to address?