Abstract:To substantiate the serviceability of aircraft gas turbine engines on the basis of technical condition, it is necessary to have information on the rate of crack growth in the material of engine components from the initial to critical dimensions. According to normative documents, this information is used in fixing the time limits for and amount of scheduled maintenance. The rate of fatigue crack growth in the high-temperature alloy of the combustion chamber of an aircraft gas turbine engine was studied taking into account operational (temperature) and constructional (weld, thickness of the product), factors. The experiments were performed on flat rectangular specimens with an edge and a central crack by the standard procedure at test temperatures of 500 and 600°C. The fatigue crack growth rate was studied in the base metal, weld and in the heat-affected zone at a distance of 2–3 mm from the weld. To do this, a fatigue crack was initiated from a mechanically cut notch at the appropriate site relative to the weld: in the base metal, weld and in the heat-affected zone. A linear section of a fatigue fracture diagram has been constructed, and Paris equation coefficients have been obtained. Confidence intervals are given, which illustrate the area within which the experimental results fall with a probability of 95%. A statistical treatment of experimental data in terms of the kinetics of fatigue crack growth in the heat-affected zone and in the base metal showed them to differ only slightly, whereas the rate of fatigue crack growth in the weld increases by a factor of two or three. To estimate the change in the mechanical properties of the alloy under investigation on transition from the base metal through the heat-affected zone to the weld, Rockwell tests were carried out. The results showed a small change in hardness, which indirectly accounts for the small discrepancy (within the statistical error) between the rate of crack growth in the base metal and that in the heat-affected zone.

Visual and microscopic examination of the rocket engine combustion chamber

Effect Of Piston Crevices On The Numerical Simulation Of A Heavy-Duty Diesel Engine Retrofitted To Natural-Gas Spark-Ignition Operation

Life evaluation of a combustion chamber by thermomechanical fatigue panel tests based on a creep fatigue and ductile damage model

Numerical Investigation of Work Cycle Characteristics in the Combustion Chamber of a Lox/Methane Liquid-Propellant Rocket Engine Featuring Reductant Power Gas Combustion

Innovative methods for obtaining artificial roughness on the surfaces of heat-loaded parts of the liquid rocket engines combustion chamber

Numerical Investigation on the Service Life of a Liquid Rocket Engine Thrust Chamber

Experimental research on the rotating detonation in gaseous fuels–oxygen mixtures

Innovative methods for obtaining artificial roughness on the surfaces of heat-loaded parts of the liquid rocket engine combustion chambers

Numerical investigation of pre-chamber holes diameter geometry on combustion parameters in a hydrogen-powered Turbulent Jet Ignition engine

Investigations on an All-Oxide Ceramic Composites Based on Al2O3 Fibres and Alumina–Zirconia Matrix for Application in Liquid Rocket Engines

An in situ combustion carbon deposit diagnostic instrument based on Raman microscopy

Investigation of thermomechanical properties of solid rocket propellant used in multi-barrel rocket systems

Development of a Solid, Low-Smoke Rocket Propellant – Smoke Generation Intensity Tests Using a Laser and Photodiode Setup

DYNAMIC BEHAVIOR OF SOLID FUEL ROCKET ENGINE DURING OPERATION (REVIEW)

Thermostructural Numerical Analysis of the Thrust Chamber of a Liquid Propellant Rocket Engine

Reusable Rocket Engine: Firing Tests and Lifetime Analysis of Combustion Chamber

Numerical simulation of combustion in the chamberof a model low-thrust rocket engine operating on the gaseous oxygen–methane components

Tribological investigation of the new combustion chamber with wall-guided fuel injection in a diesel engine

Fatigue Crack Growth in the Base Metal and Weld of the Combustion Chamber Casing of an Aircraft Gas-Turbine Engine

Gear-Shaped High- g Combustion Chamber for Micro Turbojet Engine Applications

Pseudo-Two-Dimensional Modeling and Validation of a Hybrid Rocket Combustion Chamber