Abstract:Steel slag is a solid waste which originates frrom the steelmaking industry. Its improper disposal can cause serious environmental pollution and land encroachment. Currently, recycling steel slag as aggregate for asphalt paving has been identified as an emerging sustainable way to promote the secondary reuse of solid waste. However, the functional use of steel slag aggregates still needs further exploration to maximize its utilization efficiency. This study aimed to develop a novel steel slag-based composite phase change aggregate (SS-CPCA) for snow/ice melting of asphalt pavements. Firstly, a binary n-alkane eutectic system was established to determine the binary eutectic composite of PCMs. In combination with the DSC test results, the n-tetradecane and noctadecane were screened out as the best binary eutectic composite, of which eutectic mass ratio, phase change temperature, and enthalpy were 84.4: 15.6, 2.87 degrees C, and 179.60 J/g, respectively. The SS-CPCA was then developed by using the coarse steel slag aggregate to adsorb the PCM composite while using the cement mortar as a coating. A type of SMA-13 asphalt mixture was subsequently selected and used for fabricating the SS-CPCA asphalt mixture. Finally, the pavement performance and temperature regulation performance of the SS-CPCA based asphalt mixture were tested and compared with those of the steel slag-based asphalt mixture. The test results indicated that the pavement performance properties of SS-CPCA asphalt mixture satisfied the specification requirements, verifying the feasibility of utilization of the SS-CPCA for asphalt paving. Moreover, it showed that the incorporation of SS-CPCA has the capability to increase the surface temperature of SMA-13 asphalt mixture as high as 3.4., while extending the cooling time to 780 s when the asphalt mixture surface temperature reaches 0 degrees C. These findings demonstrate that the developed SS-CPCA has a promising snow/ice melting performance for asphalt pavements.

Study on pavement performance of steel slag asphalt mixture based on surface treatment

Laboratory Evaluation On The Performance Of Porous Asphalt Mixture With Steel Slag For Seasonal Frozen Regions

Mechanical Performance Of Warm-Mixed Porous Asphalt Mixture With Steel Slag And Crumb-Rubber-Sbs Modified Bitumen For Seasonal Frozen Regions

Research application of performance of steel slag-aggregated porous cement concrete

Surface Modification of Steel Slag Aggregate for Engineering Application in Asphalt Mixture

Study on the Characteristics of Steel Slag and Its Road Performance in Asphalt Mixture

Research on the Performance of Asphalt Mixture with Acid-Treated Steel Slag Based on Microscopic Properties

Experimental Study on the Effect of Steel Slag Powder and Fine Steel Slag on the Performance of Asphalt Mixture

Pre-treatment of steel slag and its applicability in asphalt mixtures for sustainable pavements

Investigation of Permanent Deformation Behavior of Steel Slag Asphalt Mixture under Indoor Simulation

Towards the Sustainable Utilization of Steel Slag in Asphalt Pavements: A Case Study of Moisture Resistance and Life Cycle Assessment

Expansion inhibition of steel slag in asphalt mixture by a surface water isolation structure

Study on the Performance of Steel Slag and Its Asphalt Mixture with Oxalic Acid and Water Erosion

Analysis of Asphalt Mixtures Modified with Steel Slag Surface Texture Using 3D Scanning Technology

Study on the Performance of Epoxy-Modified Asphalt and Steel Slag Ultra-Thin Friction Course

Effect of Dry–Wet and Freeze–Thaw Repeated Cycles on Water Resistance of Steel Slag Asphalt Mixture

Mechanical Property Evaluation for Steel Slag in Asphalt Mixture with Different Skeleton Structures Using Modified Marshall Mix Design Methodology

Testing and Evaluation for Skid Resistance of Steel Slag Asphalt Wearing Course Based on Surface Texture Characteristics

Development and characterization of a novel steel slag-based composite phase change aggregate for snow/ice melting of asphalt pavements

Performance characterization and enhancement mechanism of recycled asphalt mixtures involving high RAP content and steel slag

Research on Improving Moisture Resistance of Asphalt Mixture with Compounded Recycled Metallurgical Slag Powders