Abstract:To scale up the capacity and spectrum efficiency in optical transmission systems, high-order quadrature-amplitude modulation (QAM), has raised a lot of research attention. Recently, optical 32 or 36QAM has been deployed to realize high spectrum-efficient Nyquist wavelength-division multiplexing transmission with spectral efficiency of up to 8.37b/s/Hz. Usually optical 32 or 36QAM is synthesized using a single in-phase/quadrature (IQ) modulator driven by 6-level driving electronics, which is referred to as “electrical” approach here. Although the single IQ modulator solution has a simple optical hardware, it requires sophisticated technique for preparing superior-quality 6-level electronics by either combining three binary electrical signals or deploying high-speed digital-to-analog converters (DACs). The operation symbol-rate is restricted by the DACs resolution, linearity of driver amplifiers or bandwidth of electrical components. On the other hand, the tandem-modulator approach, a serial combination of IQ modulators has been utilized for synthesizing various multilevel optical signals such as 8QAM and 16QAM, where only binary electronics are deployed to drive each modulator. If extending this scheme to generate higher-order QAM, we can also benefit from the reduced complexity in driving electronics. Instead of preparing superior-quality 6-level electronics for generating 36QAM, just binary and 3-level electronics are required. In contrast to the “electrical” approach, the proposed scheme provides an alternative approach to synthesize high-order QAM with simplified driving electronics.

A Simple Optimization Method for Generating High-Purity Amplitude and Phase Modulation

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

Synthetic FM triplet for AM-free precision laser stabilization and spectroscopy

Intermediate 60<sup>°</sup> Modulation with Real-time Gain Correction based on Phase-shifted Carrier

Optimizing the probability mass function of complex modulated signals through adaptive channel characterization

Optimization of the Net Residual Dispersion for Self-Phase Modulation-Impaired Systems by Perturbation Theory

A Broad-Band Analog Phase Shifter Design on I-Q Vector Modulator

Single-pixel optical modulation analyzer based on phase retrieval for dual-polarization IQ modulators

A Low Complexity Approach for Calibration and Characterization of a Millimeter Wave Phased-Array Transceiver-Antenna Module

Enhanced Imbalance-Distortion Mitigation and Noise Suppression in I/Q-Based Phase Demodulation Systems

Digital stabilization of an IQ modulator in the carrier suppressed single side-band (CS-SSB) mode for atom interferometry

IQ Mixer Calibration for Superconducting Circuits

Low-Complexity Calibration Of Joint Tx/Rx I/Q Imbalance In Wideband Direct-Conversion Transceiver

The Correction of Phase Error for MA-SOQPSK Modulation

A Hybrid Loop Two-Point Modulator Without DCO Nonlinearity Calibration by Utilizing 1 Bit High-Pass Modulation

I/Q imbalance calibration based on simulated annealing algorithm

Optimization method for universal NOLM-based phase-preserving amplitude regenerator with application to Att-NALM scheme

System impact and calibration method of power imbalances for a dual-polarization in-phase/quadrature optical transmitter

Optical 36QAM transmitter based on two tandem IQ modulators with simplified driving electronics

A New Approach for Analog to Digital Conversion Based on Double Parallel Optical Intensity Modulator