Abstract:Chemical dyes used in the textile industries are one of the major pollutants in water. Methylene blue (MB) is a commonly seen dye that creates hazardous health problems. In this article the photocatalytic degradation of MB by the nanocatalyst MoS 2 (Nano-MoS 2 ) and carbon dot (C Dots) incorporated MoS 2 (Nano-CD-MoS 2 ) is reported. The photocatalytic degradation of MB is analyzed based on the electron-hole recombination rate of the catalyst. Photoluminescence emission exhibited by the catalyst is used as a key indicator to probe the electron-hole recombination rate. Nano-MoS 2 was synthesized hydrothermally at 180 0 C for 8 h from ammonium tetra thiomolybdate (ATTM). C Dot was prepared following a green root from ash guard extract which later mixed with Nano-MoS 2 and kept in an autoclave at a temperature 140 °C for 4 h to get Nano-CD-MoS 2 . The photoluminescence (PL) and photocatalytic behavior of Nano-MoS 2 and Nano-CD-MoS 2 and their application for water splitting and water purification are reported. The incorporation of graphene and artificial C Dot into MoS 2 nanostructures are reported to increase the conductivity and active edge sites of MoS 2 that enhances the photocatalytic action. Since green C Dots are eco-friendly and easily synthesizable than artificial C Dots, as a novel study, this article investigated the influence of green C Dots on the PL and photocatalytic performance of nanosized MoS 2 . Nano-MoS 2 and Nano-CD-MoS 2 exhibited both upconversion and downconversion PL; accordingly the nanostructures were termed as amphi -luminescent. The amphi -luminescence property widens the photon absorption range and hence enhances the catalytic degradation of dyes. Nano-MoS 2 which exhibited lesser intensity of amphi -luminescence emission compared to Nano-CD-MoS 2 showed better results in degradation of MB. C Dots may bind with the valence band electrons of MoS 2 , resulting in the reduction of dangling bonds Dangling bonds can trap photo-induced excitons to hinder the rate of electron-hole recombination. So, fast electron-hole recombination occurs in Nano-CD-MoS 2 than Nano-MoS 2 . Fast electron-hole recombination supports radiative electron-hole recombination while suppresses the non-radiative energy transfer of electrons and causes high PL intensity. However, according to the energy level diagram, Nano-MoS 2 with minimal electron-hole recombination rate is more favorable for O 2 /O 2 – ,OH/ OH – andOH/H 2 O reactions that facilitate MB degradation. Photocatalytic activity of catalysts were confirmed by measuring the photocurrent from a simple custom-made two-electrode water photolysis cell where the nanocatalysts were dispersed in electrolyte. Lead and steel rods were used as electrodes. Multimeter was used to measure current. Nano-MoS 2 exhibited better performance with a maximum photocurrent of 141 μA. Influence of green C Dots in energy levels, PL and photocatalysis of MoS 2 and mechanisms of PL and degradation of MB are thoroughly investigated in this article.

Facile Hydrothermal Synthesis of Cd Doped MoS2 Nanomaterials for Degradation of Organic Pollutants: Correlation Between Experimental and COMSOL Simulation

Efficient Photocatalytic Degradation of Co Doped MoS2 Assembled by Nano-sheet and First-Principles Analysis

Fabrication of Ternary MoS2/CdS/Bi2S3-Based Nano Composites for Photocatalytic Dye Degradation

Experimental and theoretical DFT study of hydrothermally synthesized MoS2-doped-TiO2 nanocomposites for photocatalytic application

Effect of CdS loading on the properties and photocatalytic activity of MoS2 nanosheets

Zn-Doped Nanomaterials: Bridging Experimental and COMSOL Assisted Analysis for Enhanced Photocatalytic and Antimicrobial Activity

MoS2-Cu/CuO@graphene Heterogeneous Photocatalysis for Enhanced Photocatalytic Degradation of MB from Water

Green synthesis of novel lanthanum doped copper oxide nanoparticles for photocatalytic application: Correlation between experiment and COMSOL simulation

Structure, optical and visible-light photocatalytic performance of Mo1-xCoxS2 (0 ≤ x ≤ 0.1) nanoparticles synthesized by facile hydrothermal method for methylene blue dye degradation

Enhanced dye degradation using 2H-MoS2 and 1T@2H-MoS2: A comparative study

Amphi-Luminescent MoS 2 nanostructure for photocatalytic splitting of water and removal of Methylene Blue

Synthesis and Characterization of CdO/CdS Nanocomposite for the Degradation of Methyl Orange Dye

Enhanced industrial dye degradation using Co doped in chemically exfoliated MoS2 nanosheets

MoS2–CdS Composite Photocatalyst for Dye Degradation: Enhanced Apparent Quantum Yield and Reduced Energy Consumption

Preparation of MoS 2 /CdS/TNAs ternary composite structures and study of their photocatalytic properties

Simple synthesis of novel Lanthanum doped Copper oxide nanoparticles for wastewater treatment: A comparison between Experiment and COMSOL simulation

Experimental and DFT + U Investigations of the Cu1-xCdxO Nanoparticles Synthesized for Photocatalytic Degradation of Organic Pollutants: Environmental Application

Fabrication of La‐Doped MoS2 Nanosheets with Tuned Bandgap for Dye Degradation and Antimicrobial Activities, Experimental and Computational Investigations

A novel TMD/MOF (Transition Metal Dichalcogenide/Metalorganic frameworks) composite for highly and selective adsorption of methylene blue dye from aqueous mixture of MB and MO

Fabrication of CuS-MoO 3 nanocomposite for high-performance photocatalysis and biosensing

S-Schematic CuWO 4 /ZnO nanocomposite boosted photocatalytic degradation of organic dye pollutants