Abstract:In this study, we successfully synthesized a TiO2/CuO nanocomposite using the aqueous extract of Impatiens tinctoria A.rich. leaf extract as a capping, reducing, and stabilizing agent for the first time in an environmentally friendly, low-cost, straightforward, and sustainable technique. Numerous characterization techniques such as ultraviolet-visible diffuse reflectance spectroscopy (UV-vis-DRS), photoluminescence (PL), Raman spectroscopy, Fourier-transform infrared (FTIR), energy dispersive X-ray (EDX), transmission electron microscopy (TEM), X-ray diffraction (XRD), scanning electron microscopy (SEM), Brunauer-Emmett-Teller (BET), and high resolution TEM (HRTEM) were used to characterize the obtained TiO2/CuO nanocomposite. XRD verified that the TiO2/CuO nanocomposite has an average crystallite size of about 21 nm. The TEM result revealed an average particle size of 29 nm for the biosynthesized TiO2/CuO NC. The HRTEM analysis showed the presence of polycrystalline structures with the predominant lattice fringes 0.352 and 0.19 which were attributed to anatase phase TiO2 in the crystal plane of (101) and (200), respectively. The lattice fringes for monoclinic CuO were observed with values of 0.213 and 0.252 for the lattice planes of (111) and (111̅), respectively. The photoluminescence spectroscopic analysis revealed that the TiO2/CuO NC showed the lowest intensity compared to the pristine TiO2 and CuO indicating the reduction of exciton recombination in the case of the TiO2/CuO NC. The BET analysis showcased the formation of mesoporous materials with a surface area of 87.5 m2/g. The photocatalytic degradation performance of the biosynthesized TiO2, CuO, and TiO2/CuO nanomaterials against the potentially harmful MB dye was tested using the light source of a 150 tungsten-halogen lamp with a wavelength range of 360-2800 nm. The factors affecting photodegradation efficiencies like catalyst dose (20 mg), dye concentration(15 ppm), pH (9), and reaction time (90 min) were optimized for the degradation of the MB dye. The TiO2/CuO catalyst showed the highest degradation efficiency of 99% under the optimized conditions. The degradation rate of the MB dye in the presence of the TiO2/CuO NC was evaluated and found to be fitted to the pseudo-first-order kinetics with a rate constant of 0.03 min-1. The reusability test of the TiO2/CuO catalyst showed its good stability.

Preparation of nano-TiO2 sensitized by new ruthenium complex for photocatalytic degradation of methylene blue under visible light irradiation

Preparation of Novel Nanometer TiO2 Catalyst Doped with Upconversion Luminescence Agent and Investigation on Degradation of Acid Red B Dye Using Visible Light

Efficient photocatalysis of Cu doped TiO2/g-C3N4 for the photodegradation of methylene blue

Photocatalytic degradation of dyestuff wastewater under visible light irradiation using micron-sized mixed crystal TiO2 powders

Preparation and Photocatalytic Performance of Ruthenium Doped Titania Nanopowder

Preparation of C@CuNi/TiO 2 with a local surface plasmon resonance for photocatalytic degradation of organic dyes and antibiotics under visible light irradiation

Electrochemical and Photocatalytic Properties of Ru-doped TiO2 Nanostructures for Degradation of Methyl Orange Dye

Synthesis and Application of New Ruthenium Complexes Containing Β-Diketonato Ligands As Sensitizers for Nanocrystalline TiO2 Solar Cells

Irradiance-Controlled Photoassisted Synthesis of Sub-Nanometre Sized Ruthenium Nanoparticles as Co-Catalyst for TiO2 in Photocatalytic Reactions

Preparation of TiO2-Cu2O Photocatalysts and Degradation of Rhodamine B Solution under Visible Irradiation

Biosynthesis of TiO2/CuO and Its Application for the Photocatalytic Removal of the Methylene Blue Dye

Preparation, Characterization of Sulfur-Doped Nanosized TiO2 and Photocatalytic Degradation of Methylene Blue under Visible Light

Synthesis of Ruthenium-Promoted ZnO/SBA-15 Composites for Enhanced Photocatalytic Degradation of Methylene Blue Dye

g-C3N4/TiO2 nanocomposite photocatalyst for methylene blue photodegradation under visible light

Photocatalytic degradation of rhodamine B and methylene blue by electrochemically prepared nano titanium dioxide/reduced graphene oxide/poly (methyl methacrylate) nanocomposite

Enhanced visible-light catalytic degradation of methylene blue by improving adsorption of porous zirconium-based porphyrin MOFs sensitized TiO2 photocatalyst

Preparation of nano Eu3+-doped TiO2 and its photocatalytic degradation of methyl blue solution

In-situ fabrication of TiO 2 -MWCNT composite for an efficient electron transfer photocatalytic rhodamine B dye degradation under UV–visible light

Low-Temperature Preparation of Phthalocyanine-Sensitized Mischcrystal Tio2 Film and Its Catalysis for Degradation of Rhodamine B

Synthesis of Efficient Nanosized Rutile Tio2 and Its Main Factors Determining Its Photodegradation Activity: Roles of Residual Chloride and Adsorbed Oxygen

TiO2-x/Ag/rGO composites as effective photocatalysts for degradation of organic pollutants