Abstract:N-type bismuth telluride (Bi2Te3) thin films were prepared on an aluminum nitride (AlN)-coated stainless steel foil substrate to obtain optimal thermoelectric performance. The thermal co-evaporation method was adopted so that we could vary the thin film composition, enabling us to investigate the relationship between the film composition, microstructure, crystal preferred orientation and thermoelectric properties. The influence of the substrate temperature was also investigated by synthesizing two sets of thin film samples; in one set the substrate was kept at room temperature (RT) while in the other set the substrate was maintained at a high temperature, of 300 °C, during deposition. The samples deposited at RT were amorphous in the as-deposited state and therefore were annealed at 280 °C to promote crystallization and phase development. The electrical resistivity and Seebeck coefficient were measured and the results were interpreted. Both the transport properties and crystal structure were observed to be strongly affected by non-stoichiometry and the choice of substrate temperature. We observed columnar microstructures with hexagonal grains and a multi-oriented crystal structure for the thin films deposited at high substrate temperatures, whereas highly (00 l) textured thin films with columns consisting of in-plane layers were fabricated from the stoichiometric annealed thin film samples originally synthesized at RT. Special emphasis was placed on examining the nature of tellurium (Te) atom based structural defects and their influence on thin film properties. We report maximum power factor (PF) of 1.35 mW/m K2 for near-stoichiometric film deposited at high substrate temperature, which was the highest among all studied cases.

Study Of Structural and Optical Properties Of Tl2Te3 Thermally Evaporation Thin Films

Structural and Thermodynamic Properties of Pb-Cd-Te Thin Films: Experimental Study and DFT Analysis

Investigation of structural and optical characteristics of thermally evaporated Ga2Se3 thin films

The Annealing Temperature Effect Enhances the Structural and Optical Parameters of Bi2Te3 Thermally Evaporated Thin Films

Preparation and investigation of structure, optical, nonlinear optical and thermoelectric properties of Bi2Se3 thin film

Studies of Structure,Composition and Photoelectric Properties of CdTe Thin Film Grown by Vacuum Sublimation

Phonon and Thermal Properties of Exfoliated Tantalum Diselenide Thin Films

Synthesis and Characterization of Bi2Te3 Nanostructured Thin Films

First‐Principles Calculations to Investigate the Ground State, Mechanical Stability, Electronic Structure, and Optical Properties of Tl2SnX3 (X = S, Se, Te)

An investigation of structural, thermo-physical, and photoelectric properties of glassy As2Se3–Tl2Te3 alloys

Thermoelectric behavior of Tl2GaInTe4 crystals

Thermal Evaporated Te-Bi 2 Te 3 Alloy Thin Film and Its Nonlinear Optical Properties

Thermal stability and crystallization kinetic of Se-Te-Ag glassy alloys and thick films for electronic devices

Effect of composition and structure of In-Te alloy on evaporation property and film of Te

Preparation of InSe Thin Films by Thermal Evaporation Method and Their Characterization: Structural, Optical, and Thermoelectrical Properties

Fabrication, micro-structure characteristics and transport properties of co-evaporated thin films of Bi2Te3 on AlN coated stainless steel foils

Effect of Doped Aluminium into Bismuth Telluride on the Structural and Optical Properties by Thermal Evaporation

Physical properties of Thallium-Tellurium based thermoelectric compounds using first-principles simulations

Effect of annealing temperature on the structural and optical properties of vacuum evaporated Cu13Se52Bi35 thin films

Study of the Crystal Structure, Band Gap and Dispersion Evolution in Titanium Oxide Thin Films

Structural and optical properties of Te doped CdS films