Abstract:It is demonstrated that cuprous oxide (Cu2O) can be electrodeposited epitaxially onto silicon (Si) and indium phosphide (InP) (001) single‐crystalline substrates from aqueous solution. Epitaxial electrodeposition under these conditions is remarkable considering the strong driving force for the formation of amorphous native oxide layers on Si and InP substrates. To elucidate the growth mechanisms, the microstructure of the interfaces between the Cu2O layer and the two different substrates was investigated by TEM (transmission electron microscopy) in conjunction with XEDS (X‐ray energy‐dispersive spectroscopy) and EELS (electron energy‐loss spectroscopy). In both heteroepitaxial systems, the Cu2O layers have a unique but non‐trivial crystallographic orientation relationship (OR) with the substrate, which can be described as a 45° rotation around the common [001] axis representing the substrate normal. We show that this relationship minimizes the overall misfit between corresponding interatomic spacings of the two adjacent crystals. In apparent contradiction to the unique OR, TEM revealed that in both hetero‐systems the Cu2O layer is separated from the substrate by an amorphous interlayer. The thickness of the interlayer typically is a few nanometers. The presence of an amorphous interlayer contrasts with our experimental results on electrodeposited Cu2O on Au (001) single‐crystal substrates, also included in this article, where TEM shows the Cu2O epilayer in direct contact with the substrate. XEDS and EELS analysis of the chemical composition and bonding at Cu2O/Si and Cu2O/InP interfaces in the as‐grown state as well as after tempering revealed that the interlayer is mainly composed of SiO2 and InPO4, respectively. Most likely, the observed epitaxial layers on top of an amorphous interlayer evolve by nucleation of epitaxial Cu2O directly on the substrate. While simultaneous oxidation of the substrate leads to the formation of an amorphous layer, the epitaxial nuclei can laterally overgrow the oxide. Consequently, the local composition of the amorphous layer varies with the nature of the substrate.

Substrate Effect on Liquid Petroleum Gas Sensors of Cuprous Oxide Thin Films Electrodeposited in Acetate Bath

The pH-dependent properties of cuprous oxide thin films prepared by electrochemical deposition for liquid petroleum gas sensing

Nebulized spray pyrolysis deposited CdO thin films for liquefied petroleum gas and ethanol gas sensor

Effect of Conductive Substrate (working Electrode) on the Morphology of Electrodeposited Cu2O

Effects of withdrawal speeds on the structural, morphological, electrical, and optical properties of CuO thin films synthesized by dip-coating for CO2 gas sensing

DEPOSITION OF CDO THIN FILMS BY DIP COATING TECHNIQUE AND THE EFFECT OF CONCENTRATION ON GAS SENSOR APPLICATIONS

Enhanced Sensing Performance of Electrospun Tin Dioxide Nanofibers Decorated with Cerium Dioxide Nanoparticles for the Detection of Liquefied Petroleum Gas

In-Depth Study of Chemically Electrodeposited Cuprous Oxide (Cu2O) thin Films on ITO Glass

Influence of Substrate Surface Roughness on the Properties of a Planar-Type CO2 Sensor Using Evaporated Li3PO4 Film

EPITAXIAL GROWTH OF CUPROUS OXIDE ELECTRODEPOSITED ONTO SEMICONDUCTOR AND METAL SUBSTRATES

Room temperature LPG sensing of highly responsive Ag-doped CuO: SnO 2 nanocomposite film.

Influence Different Substrates on the Sensing Performance of Copper Oxide Thin Films Synthesis via the Hydrothermal Method

Study of p-n Heterojunction Thin Films for Reducing Gas Sensing Application Fabricated by Thermal Evaporation Technique

A fast responsive and highly reproducible liquefied petroleum gas (LPG) detection of CuxZn1-xSb2O6 (x = 0, 0.2, 0.4, 0.6, and 0.8) nanostructures

Characterizations of Cuprous Oxide Thin Films Prepared by Sol-Gel Spin Coating Technique with Different Additives for the Photoelectrochemical Solar Cell

Fabrication of thin film potentiometric CO2 sensors on differentiate substrate surfaces and their characteristics

Enhanced gas sensing performance of ZnO and Pt-doped ZnO nanostructured films by chemical spray pyrolysis

Deposition and diffusion of Pd on SnO2 thin-film and its effect on gas-sensing property

Characterization of Porous CuO Films for H2S Gas Sensors

Effects of Bath Temperature and Substrate on Surface Morphology of Electrodeposited Cu2O Thin Films

Exposure Surface Active Sites of Perovskite‐Type LaFeO3 Gas Sensors by Selectively Dissolving La Cations for Enhancing Gas Sensing Properties to Acetone