Abstract:The paper evaluates the results of tests performed using mid- and high-level blends of the low-carbon alcohols, methanol and ethanol, in admixture with gasoline, conducted in a variety of test engines to investigate octane response, efficiency and exhaust emissions, including those for particulate matter. In addition, pure alcohols are tested in two of the engines, to show the maximum response that can be expected in terms of knock limit and efficiency as a result of the beneficial properties of the two alcohols investigated. All of the test work has been conducted with blending of the alcohols and gasoline taking place outside the combustion system, that is, the two components are mixed homogeneously before introduction to the fuel system, and so the results represent what would happen if the alcohols were introduced into the fuel pool through a conventional single-fuel-pump (dispenser) approach. While much has been written on the effect of blending the light alcohols with gasoline in this way, the results present significant new findings with regard to the effect of the enthalpy of vaporization of the alcohols in terms of particulate exhaust emissions. Also, in one of the tests, two mid-level blends are tested in a highly downsized prototype engine – these blends being matched for stoichiometry, enthalpy of vaporization and volumetric energy content. The consequences of this are discussed and the results show that this approach to blend formulation creates fuels which behave in the same manner in a given combustion system; the reasons for this are discussed. One set of tests using pure methanol alternately with cooled exhaust gas recirculation and with excess air shows a significant increase in thermal efficiency that can be expected as the blend level is increased. The effect on nitrous oxide emissions is shown to be similarly beneficial, this being primarily a result of the enthalpy of vaporization of the alcohol cooling the charge coupled with the lower adiabatic flame temperature of the alcohol. Whereas it is normally a beneficial characteristic in spark-ignition combustion systems, one disadvantage of a high value of enthalpy of vaporization is shown in another series of tests in that, in admixture with gasoline, it is a driver on flash boiling of the hydrocarbon component in the blend in direct injection combustion systems. In turn, this causes the particulate emissions of the engine to increase quite markedly over those of ethanol–gasoline blends at the same stoichiometry. The paper shows for the first time the dichotomy of the potential efficiency improvement with the challenge of particulate control. This effect poses a challenge for the future introduction and use of such high blend rate fuels in engines without particulate filters. Although it must be stated that the overall particulate emissions of the methanol–gasoline blend are lower than for gasoline, the effect is only present at extremely low load, and that there is a likelihood that particulate filters will be adopted in production vehicle anyway, nullifying this issue.

Effect of low percentage methanol blends in gasoline RON 90 on fuel volatility characteristics and spark ignition engine performance

Engine Performance and Emissions of A Compression Ignition Engine Operating on the Diesel-Methanol Blends

Combustion and Emission Characteristics of a DI Diesel Engine Fueled by Diesel-Methanol Blends

Effects of Methanol/Gasoline Blends on a Spark Ignition Engine Performance and Emissions

Evaluation of performance and emissions characteristics of methanol blend (gasohol) in a naturally aspirated spark ignition engine

The Effects of Methanol Fraction on the Azeotropic Behaviors of Methanol/Gasoline Mixtures

Effects of Methanol Application on Carbon Emissions and Pollutant Emissions Using a Passenger Vehicle

Impact of Adding Bioethanol and Dimethyl Carbonate on Gasoline Properties

Combustion And Emission Characteristics Of Gasoline Blended With Alcohols

Influence of methanol gasoline blend fuel on engine and catalyst performance

Unregulated Emissions and Combustion Characteristics of Low-Content Methanol−Gasoline Blended Fuels

Methanol As an Octane Booster for Gasoline Fuels

Influence of Higher Alcohol Additives in Methanol–Gasoline Blends on the Performance and Emissions of an Unmodified Automotive SI Engine: A Review

Experimental Investigation on the Emissions of a Port Fuel Injection Spark Ignition Engine Fueled with Methanol–Gasoline Blends

Study on Combustion Characteristics of a DI Diesel Engine Operating on Diesel/Methanol Blends

Impact of various lambda values on engine performance, combustion and emissions of a SI engine fueled with methanol-gasoline blends at full engine load

Alcohol fuels for spark-ignition engines: Performance, efficiency and emission effects at mid to high blend rates for binary mixtures and pure components

Performance and emissions evaluation of a multi-cylinder research engine fueled with ethanol, methanol, gasoline Euro-6, E85, and iso-stoichiometric ternary GEM mixtures operated at lean conditions

Effects of Methanol-Gasoline Blend on Gasoline Engine Performance and Emissions

Performances of electronic fuel injection engine fueled with methanol-gasoline blended fuel