Abstract:The catalyst layer (CL) was an important component in polymer electrolyte fuel cells (PEFCs). In the CL, Nafion ionomers coated the Pt particles on the carbon surface for the proton transfer assistance, and therefore the structure optimization of ionomer films is very important for the improvement of catalytic utilization and proton transport performance. The microscopic structure of ionomer covered carbon and Pt particles in the solution was related to the final structural characteristics of the ionomer film determining the performance of CL. In order to elucidate the structural evolution and drying process of the catalyst ink, in the present study, we carried out coarse-grained molecular dynamics (CGMD) simulations to investigate the adsorption behavior of ionomers and morphology evolution of Nafion ionomer from the aqueous solutions to the Pt/C substrate surface under various solution conditions including ionomer concentration and I/C ratio, and substrate conditions including the size and distribution of Pt particles, and Pt/C ratio. We found that the ionomers formed a cylindrical aggregate in the solution and are easily attracted by Pt particles due to their hydrophilic ionic shells. Although ionomer aggregates are easily to adsorb onto Pt particles, it tended to unfold and spread onto the carbon substrate finally, which is resulted from the hydrophobic attraction of the exposed ionomer backbone to the carbon surface and the hydrophilic attraction of ionomer sulfonate groups to the aqueous solution. The ionomer adsorption displayed a strong correlation with the ionomer concentration in the dilute solution. However, the I/C ratio had little effect on ionomer adsorption. This adsorption phenomenon of ionomers in the dilution solution was found to fit the Langmuir adsorption model very well but failed when the concentration of ionomer became higher. A wettability switching behavior of ionomers is observed because the morphology of ionomers changed from the solution to the surface. Two types of the adsorption behavior of ionomer aggregates in the aqueous solution were observed. The first adsorption behavior was the direct adsorption of ionomer aggregate to the carbon substrate without any interaction with Pt particles. For the ionomer aggregate, exposed apolar backbones of ionomers that were close to the carbon could help the ionomer aggregate adsorb on the hydrophobic carbon surface. During the adsorption process, cylindrical-like shape ionomer aggregates gradually spread onto the carbon surface. Finally, the ionomers were entirely distributed on the carbon surface without aggregating together. The second adsorption behavior was indirect adsorption of ionomer aggregate, where the ionomer aggregates firstly adsorbed onto the Pt particles from solution, and finally to the carbon substrate. In the solution, the apolar backbones of ionomer aggregates located at the core of the aggregate were difficult to contact with the substance outside such as carbon surface, while the anionic groups located at the aggregate-solvent interface were easy to contact with the substance outside. When such Nafion aggregates were close to the Pt particles, the anionic shells of the cylindrical aggregates were easily to adsorb onto hydrophilic Pt particles. When the Nafion aggregate adsorbed onto Pt particles, Nafion still presents a cylinder-like aggregate state until it started to approach the carbon surface. When the Nafion aggregate begin to move onto the carbon substrate, it gradually unfolded due to the strong hydrophobic interaction between the ionomer backbone and the carbon surface. During this process, Nafion ionomers gradually relieved their internal hydrophobic associations between their backbones because the unfolded ionomers created more surface contacts and better anchored themselves to the surface. Therefore, when the exposed carbon surface was large enough, increasing the number and sizes of Pt particles could increase the surface area of Pt particles, which favors the ionomer adsorption. When the space between Pt particles was too small to create enough carbon surface contacts anchoring the ionomer backbone, the coverage of the ionomer dropped rapidly. The present study provided insight into ionomer adsorption from solutions to Pt/C surface, which could contribute to the catalyst ink design to improve the structure of catalyst layers. Acknowledgments This work was supported by the New Energy and Industrial Technology Development Organization (NEDO) of Japan, Grant number JPNP20003. It was performed on the Supercomputer system "AFI-NITY" at the Advanced Fluid Information Research Center, Institute of Fluid Science, Tohoku University. We also thank W. Shirakawa for her assistance with the simulations.

Interfacial Distribution of Nafion Ionomer Thin Films on Nitrogen-Modified Carbon Surfaces

Localized Electrochemical Impedance Measurements on Nafion Membranes: Observation and Analysis of Spatially Diverse Proton Transport Using Atomic Force Microscopy

Localized Electrochemical Impedance Measurements on Nafion Membranes: Observation and Analysis of Spatially Diverse Proton Transport Using Atomic Force Microscopy.

Nafion structural phenomena at platinum and carbon interfaces

Morphology of Thin-Film Nafion on Carbon as an Analogue of Fuel Cell Catalyst Layers

Inhibition of Ionomer Specific Adsorption on Pt/C Catalysts Coated with Dopamine-Derived Nitrogen-Doped Carbon

Anode Catalytic Dependency Behavior on Ionomer Content in Direct CO Polymer Electrolyte Membrane Fuel Cell

Effects of Dispersion Solvents on Proton Conduction Behavior of Ultrathin Nafion Films in the Catalyst Layers of Proton Exchange Membrane Fuel Cells

Influence of ionomer content on the structure and performance of PEFC membrane electrode assemblies

Uniform Nafion

Potential-Dependent Ionomer Rearrangement on the Pt Surface in Polymer Electrolyte Membrane Fuel Cells

An Ingenious Design of Nanoporous Nafion Film for Enhancing the Local Oxygen Transport in Cathode Catalyst Layers of PEMFCs

Uniform Nafion (R) Coated Hra Anode For High Performance Micro Dmfc

Modification for Uniform Surface of Nafion Ultrathin Film Deposited by Inkjet Printing

Control of surface area and conductivity of niobium-added titanium oxides as durable supports for cathode of polymer electrolyte fuel cells

Molecular Simulation of Nafion Swelling in the Cathode Catalyst Layer of Polymer Electrolyte Fuel Cells

Carbon Nanofiber Gas-Diffusion Anodes Based on a Copolymer of Acrylonitrile with Methyl Acrylate for High-Temperature Polymer-Electrolyte Membrane Fuel Cell

Functional Electrochemically-Active Ultra-Thin Nafion Films

Molecular Dynamics Study of Adsorption Phenomenon of Aromatic Hydrocarbon Ionomer in Catalytic Layer of Polymer Electrolyte Fuel Cell

(Digital Presentation) A Coarse-Grained Molecular Dynamics Study on the Aggregation and Adsorption Behavior of Ionomer from Solution Onto Pt/C Substrate

Operando X-Ray Absorption Spectroscopic Study on Influence of Specific Adsorption of Sulfo Group in Perfluorosulfonic Acid Ionomer Towards ORR Activity of Pt/C Catalyst