Abstract:Abstract Shale gas, as an unconventional resource, has become an exploration and exploitation hotpoint in China. In this paper, a series of experiments were conducted to investigate petrophysical and mechanical properties on the gas shales in Longmaxi Formation south Sichuan Basin, China. Mineralogical and organic geochemical analysis results indicate shale matrix shows strong heterogeneity and structure complexity. A positive correlation between TOC and quartz indicates that bioclastics are the main source of both siliciclastic and organic matters in anaerobic environment. Pore structure was investigated by mercury injection and nitrogen adsorption measurements. The dominant pore size distributes below 3.7nm measured by mercury injection, while 3-5nm by nitrogen adsorption. Micronsized fractures and nanopore structure of shale samples had been identified through mercury saturation curves and adsorption-desorption isotherms. The average maximum mercury saturation is less than 50% at 414MPa, and all of the nanopores were slit-shaped (Type H3 adsorption-desorption isotherms). The BET specific surface area which was calculated from nitrogen adsorption ranges between 7-19 m2/g and have an obvious positive relationship with TOC (total organic matter content) and illite-montmorillonite mixed layer content. Pulse decay measurement reveals that an exponential function can describe the permeability deterioration upon applied effective stress. The stress-dependent permeability of shale is more sensitive than sandstone because of high pore compressibility (low aspect ratio of pore and elastic moduli). The stress-dependent permeability data of samples with micronsized fractures can also be excellently fitted by Walsh model (fractured porous media permeability model), and fitting results show that the fractures in shale samples have high roughness and small aperture compared with sandstone. Static Young's modulus of shale samples increase with increasing quartz, and decrease with increasing TOC and clay minerals content. Due to the weak mechanical property of montmorillonite, shale samples show viscoelastic behaviour and relatively weak mechanical parameters (low Young's modulus, cohesive strengths and friction coefficients, high possion's ratio) under triaxial compression conditions. With the increasing of confining pressure, shales gradually transform from brittleness to ductileness. A comparison of static mechanical parameters between our samples and North America indicates that black siliceous shales of Longmaxi formation have moderate Young's modulus and Poisson's ratio.

Investigation on Mechanical Properties, AE Characteristics, and Failure Modes of Longmaxi Formation Shale in Changning, Sichuan Basin, China

Experimental Study on Mechanical Behavior and Brittleness Characteristics of Longmaxi Formation Shale in Changning, Sichuan Basin, China

Study on Mechanical Characteristics and Damage Mechanism of the Longmaxi Formation Shale in Southern Sichuan Basin, China

Study on Mechanical Properties and Failure Modes of Longmaxi Shale

Anisotropic Mechanism and Characteristics of Deformation and Failure of Longmaxi Shale

Laboratory Geomechanical and Petrophysical Characterization of Longmaxi Shale Properties in Lower Silurian Formation, China

Brittleness Evaluation of Organic-Rich Shale in Longmaxi Formation in Dingshan Area, Southeastern Sichuan

A comprehensive evaluation methodology of shale brittleness:A case study from the Lower Silurian Longmaxi Fm in Block W, Sichuan Basin

Brittleness Evaluation of the Shale Reservoirs in Wufeng and Longmaxi Formation in the DS Area, Southeast Sichuan, China

Triaxial tests on weak planes damage of hard brittle shale of Longmaxi formation in South Sichuan Basin, China

Evaluation of Petrophysical and Mechanical Features for Shale Gas Reservoirs in South Sichuan Basin, China

Evaluation on the Anisotropic Brittleness Index of Shale Rock Using Geophysical Logging

Mechanical Behavior Investigation of Longmaxi Shale under High Temperature and High Confining Pressure

The investigation on shale mechanical characteristics and brittleness evaluation

Shale brittleness evaluation under high temperature and high confining stress based on energy evolution

Experimental research on anisotropic properties of shale

Investigation on failure behavior and hydraulic fracturing mechanism of Longmaxi shale with different bedding properties

Investigation on the Anisotropy of Meso-Mechanical Properties of Shale Rock Using Micro-Indentation

Effects of Mineral Composition and Lamina on Mechanical Properties and Fractures of the Wufeng-Longmaxi Shale in the Luzhou Area of the Southern Sichuan Basin

Assessment of the Multiphase Mechanical Properties of the Longmaxi Formation Shale Using Nanoindentation Tests

Experimental Study on the Uniaxial Compression Failure and Ultrasonic Transmission of Brittle Shale Considering the Bedding Effect