Abstract:<p>A circumferential crack in the fusion line is a major threat to the structural integrity of the pipeline girth weld because it may possibly lead to fracture failure when subjected to large plastic deformations. For the newly constructed X80 pipeline with an outside diameter (OD) of 1422 mm in China, the complicated configuration of welded joints and the outer diameter are outside the range of the general fracture assessment standards, such as BS 7910. Furthermore, during the pipe manufacture process, pipeline designers merely specify the minimum yield strength limit according to the pipe steel grade. This results in a wide variation range in the choice of yield strength values of the base metal. This also leads to a serious problem in the fracture assessment of pipe girth weld because the weld strength is commonly considered to be either evenly matched or overmatched. The foregoing factors make it difficult to perform an accurate fracture assessment using conventional standards. This study therefore aims to investigate the fracture behavior of 1422-mm OD pipelines with a double-V groove weld and circumferential crack in the fusion line. The specific effect of material mismatch and the realistic operational parameters that influence the fracture capacity of the pipe are examined via a series of numerical investigations. First, a rigorous three-dimensional finite element model to simulate the pipe girth weld is established by utilizing the ABAQUS finite element code package. The weld, which has a canoe-shaped surface crack in the fusion line between the heat-affected zone and root welding metal, is subjected to biaxial loading conditions. The keyhole method is adopted to simulate the crack front as well as the crack tip to eliminate the stress singularity effect during deformation. A refined mesh strategy is introduced to ensure the accurate simulation of the stress and strain fields in the vicinity of the crack tip. Based on the numerical model, the J-integral fracture parameter, which is clearly defined based on a strict mechanical theory, is chosen to characterize the effect of strength matching ratio, internal pressure, and yield to tensile strength ratio on the crack driving force. A new strain-based J-integral prediction formula is proposed based on numerical results.</p>

Analysis of Crack Resistance of an Oil Trunk Pipeline Considering the Varying Failure Viscosity in the Neighborhood of a Welded Joint

Novel approach for numerical evaluation of limiting state and reliability of corroded pipelines under in-service repair welding

Fracture behavior analysis of X80 pipelines welded joints with unequal wall thickness

Deformation and fracture of a thick-walled pipeline made of nonlinearly elastic material

Fracture response of 1422-mm diameter pipe with double-V groove weld joints and circumferential crack in fusion line

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

ON THE TOUGHNESS-INDUCED CRACK DECELERATION MECHANISM OF GAS PIPELINES TRANSMITTING GAS FROM THE WEST TO THE EAST

The Influence of Operational Degradation of Material on the Residual Life of Oil Pipelines

Damage and cracking of hydrogenation pipelines suffered from thermal fatigue

Effect of welding axial stresses on the strength of a welded pipe joint with a defect

A Damage Mechanics based Evaluation of Dynamic Fracture Resistance in Gas Pipelines

Failure Analysis of Girth Weld Cracking in Gas Transmission Pipelines Subjected to Ground Subsidence and Traffic Loads

Failure Analysis of Cracked P110 Repaired Tubing Used for Gas Transmission

Failure Analysis and Fitness-for-service Assessment for a Pipeline

Failure analysis of corrosion at an inhomogeneous welded joint in a natural gas gathering pipeline considering the combined action of multiple factors

Modeling the Crack Interference in X80 Oil and Gas Pipeline Weld

The impact of residual technological stresses on the opening and stability of through cracks in pipeline elements

Fracture analysis of X80 welded joints with variable wall thickness and misalignment

On the Ratchet Analysis of a Cracked Welded Pipe

The Toughness-Induced Crack Deceleration Mechanism on Ultra-High Pressure Steel Gas Pipelines

Analysis of Crack Propagation of Annular Butt Weld and Distribution of Weld-Induced Residual Stress