Abstract:ZnO nanocrystals doped transparent glass and glass-ceramics with visible emissions were successfully synthesized through melt-quenching method. Structures and defect-related photoluminescence of quenched glasses and glass-ceramics were significantly dependent on ZnO content in precursor and post heat treatment time. Nano-sized ZnO crystals could generate in quenched glass before heat treatment with a particular precursor composition (44SiO(2)-11Al(2)O(3)-40ZnO-10K(2)O, mol%), and this quenched glass emitted strong green emission. For glass-ceramics, short time (5 min) heat treatment was conducive to intensive green or yellow emission depending on the excitation energy. Further extending of heat treatment resulted in yellow emission as the dominant one, together with a decline of intensity due to reduced defects. Moreover, the emission peaks shifted towards longer wavelength, from violet, blue, to green and yellow, with an increase of heat treatment time, which can be ascribed to different defect states along with crystal growth during heat treatment. Green light corresponded to oxygen vacancies (V-0), the main defect of ZnO before heat treatment, whereas yellow light was associated with the transition from zinc interstitials (Zn-i) to oxygen interstitials (O-i) produced with the structure transformation during heat treatment. Yellow emission can emit with both above- and below-bandgap excitation, and preferentially excited by energy (395 nm, similar to 3.14 eV) below the bandgap, near Zn-i level. Green emission was only efficient under the excitation larger than bandgap. Defect-based mechanisms of visible emissions with different initial states were proposed. (C) 2018 Elsevier B.V. All rights reserved.

Temperature Dependence of the Phase Transformation and Photoluminescence Properties of Metastable ZnWO4 Nano-Phosphors with High UV Absorption and VIS Reflectance

Synthetic and Effect of Annealing on the Luminescent Properties of Zno Nanowire

Effect of Solution Concentrations on Crystal Structure, Surface Topographies and Photoluminescence Properties of ZnO Thin Films

Effect of the Sintering Process on the Structure, Colorimetric, Optical and Photoluminescence Properties of SrWO4 Phosphor Powders

Fabrication and Visible Emissions of ZnO Nanocrystal Doped Transparent Zinc Silicate Glass-Ceramics

Temperature-Dependent Photoluminescence of Nanostructured ZnO

Influence of Temperature on the Morphology and Luminescence of ZnO Micro and Nanostructures Prepared by CTAB-assisted Hydrothermal Method

Low-temperature Microwave Synthesis and Luminescence Properties of Far-Red Emission ZnGa2O4:Cr3+ Phosphor for Plant Cultivation

Preparation and Characterization of ZrO2:Eu3+ Phosphors

Microsphere Morphology Tuning and Photo-Luminescence Properties of Monoclinic Y2wo6

Effects of sintering temperature and phase transition on the photoluminescence and triboluminescence of manganese doped zinc sulfide

Metastability effects on the photoluminescence of ZnO nano-micro structures grown at low temperature and influence of the precursors on their morphology and structure

Temperature and Pressure Dependent Luminescence Mechanism of Zinc-Blende Structured ZnS:Mn Nanophosphor under UV and X-ray Excitations

Preparation, photoluminescence and photocatalytic properties of ZnO:Eu3+ nanocrystals

Sol-Gel Synthesis and Luminescence Properties of ZnMoO4:Tb3+ Nano-Structural Materials

Synthesis of Nanometer Y2o3 : Eu Phosphor and Its Luminescence Property

Temperature and Pressure Dependent Luminescence Mechanism of Zinc-Blende Structured ZnS:Mn Nanophosphor under UV Excitation

Silica encapsulated ZnO quantum dot-phosphor nanocomposites: Sol-gel preparation and white light-emitting device application

Full-color Photoluminescence of ZnO Nanorod Arrays Based on Annealing Processes

Fabrication of Nanocrystalline Znwo4 with Different Morphologies and Sizes Via Hydrothermal Route

Color-Tunable Emission of ZnO/Ag2O/MnO2 Nanocomposite Phosphor for Solid-State Lighting Applications