Abstract:This research examines the potential of a synthetic e-diesel and oxymethylene dimethyl ether blend in a heavy-duty single-cylinder engine. The main purpose is to find the optimal engine settings that maximize engine efficiency and minimize emissions. As the first step, a methodology was developed and applied to simplify the engine's map into five characteristic points to be representative of the World Harmonized Transient Cycle, assigning weights to each load region. This simplification reported low error estimations for fuel consumption and NOx emissions over the cycle. After obtaining the five points, a drop-in analysis was assessed, where the fuel was evaluated with the same settings as diesel, revealing more advanced and shorter combustion with great reductions in soot emissions. Then, a group of three air management and three injection parameters was selected for optimization. A novel methodology combining Taguchi Design and Response Surface Methodology is developed and applied to find the best engine settings. By integrating these two methods, the research reduced the number of required experiments if only one method were used and maintained the goal of achieving higher thermal efficiencies with the new fuel blend compared to the diesel baseline. Significant statistical results were obtained in the Taguchi design, revealing the air management factors that most affected the responses; meanwhile, second-order models with high accuracy helped in finding the best injection parameters. Subsequently, the best settings were experimentally evaluated, and optimal conditions determined by the two methods were validated, confirming the effectiveness of the methodology. Optimization results revealed an improvement of around 2% higher efficiencies for the five tested points while achieving important average reductions of 28% less in NOx with additional decreases in CO, HC, and soot levels, all outperforming traditional diesel benchmarks. Finally, a well-to-wheel analysis using the simplified cycle confirmed a substantial reduction in carbon impact when replacing diesel with this alternative fuel. The successful application of this methodology to recalibrate an engine with an alternative fuel blend shows the potential of using these fuels in existing engines and offers a novel methodology that can be escalated and applied under the engine calibration context.

Maximizing Lubricant Life for Internal Combustion Engines

Research and Applications on the Optimizing and Blending of Lubricating Oil System

The Effects of Ultra-Low Viscosity Engine Oil on Mechanical Efficiency and Fuel Economy

Wear protection assessment of ultralow viscosity lubricants in high-power-density engines: A novel wear prediction algorithm

Experimental Investigation of Tribological and Rheological Behaviour of Hybrid Nanolubricants for Applications in Internal Combustion Engines

Friction assessment of ultralow viscosity lubricant formulations based on a validated elastohydrodynamic simulation

Practical applications of lubrication models in engines

Engine Lubrication System for Oil Flow Reduction

Synergy Study Between a Lubricant Oil Layer and a Microstructural Graphite to Reduce Friction and Wear of a Thermally Modified Low-Carbon Gray Cast-Iron Cylinder Liner

Design of experiments coupled with Bayesian optimisation for nanolubricant formulation

Particulate Matter Emission and Air Pollution Reduction by Applying Variable Systems in Tribologically Optimized Diesel Engines for Vehicles in Road Traffic

Optimization methodology combining Taguchi design and response surface method to maximize a compression ignition engine efficiency fueled with oxygenated synthetic fuel

Friction and Wear Performance Evaluation of Bio-Lubricants and DLC Coatings on Cam/Tappet Interface of Internal Combustion Engines

Piston ring–liner lubrication and tribological performance evaluation: A review

Deterministic Simulation of Surface Textures for the Piston Ring/Cylinder Liner System in a Free Piston Linear Engine

Optimization of Piston-Ring System for Reducing Lube Oil Consumption by CAE Approach

Latest advancements in the lubricant simulations of geared systems: a technology ready for industrial applications

Hybrid digital twin for conditional lubricant oil transport simulation and oil consumption prediction in internal combustion engines

Experimental Study on the Effect of Marine Engine Lubricant Degradation on Tribological Performance of Cylinder Liner and Piston Rings Contact Using a Tuning Fork Technology Based Oil Sensor

Multi-objective optimization of lubricant volume in an ELSD considering thermal effects

Design and optimization of textures on the surface of crankpin bearing to improve lubrication efficiency and friction power loss of engine