Abstract:Currently, relatively large errors are found in numerical results in some low-specific-speed centrifugal pumps with unshrouded impeller because the effect of clearances and holes are not accurately modeled. Establishing an accurate analytical model to improve performance prediction accuracy is therefore necessary. In this paper, a three-dimensional numerical simulation is conducted to predict the performance of a low-specific-speed centrifugal pump, and the modeling, numerical scheme, and turbulent selection methods are discussed. The pump performance is tested in a model pump test bench, and flow rate, head, power and efficiency of the pump are obtained. The effect of taking into consideration the back-out vane passage, clearance, and balance holes is analyzed by comparing it with experimental results, and the performance prediction methods are validated by experiments. The analysis results show that the pump performance can be accurately predicted by the improved method. Ignoring the back-out vane passage in the calculation model of unshrouded impeller is found to generate better numerical results. Further, the calculation model with the clearances and balance holes can obviously enhance the numerical accuracy. The application of disconnect interface can reduce meshing difficulty but increase the calculation error at the off-design operating point at the same time. Compared with the standard k-ɛ, renormalization group k-ɛ, and Spalart-Allmars models, the Realizable k-ɛ model demonstrates the fastest convergent speed and the highest precision for the unshrouded impeller flow simulation. The proposed modeling and numerical simulation methods can improve the performance prediction accuracy of the low-specific-speed centrifugal pumps, and the modeling method is especially suitable for the centrifugal pump with unshrouded impeller.

The Estimation of Centrifugal Pump Flow Rate Based on the Power–Speed Curve Interpolation Method

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Ultra-clean Bellows Pump Flowrate Prediction Based on Multi-sensor Information Fusion with Noncontact Magnetic Tagged Bellow Deformation Derivation

Multi-Objective Optimization of Multistage Centrifugal Pump Based on Surrogate Model

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Whole flow field performance prediction by impeller parameters of centrifugal pumps using support vector regression

Identification of centrifugal pump flow based on feature recognition

Influence of turbulence model on performance prediction of mixed-flow pump

Energy Performance Curves Prediction of Centrifugal Pumps Based on Constrained PSO-SVR Model

Probabilistic Modeling and Prediction of Dynamic Discharge Process in Multiphase Pumps

Investigation of CFD Calculation Method of a Centrifugal Pump with Unshrouded Impeller

Energy performance prediction of the centrifugal pumps by using a hybrid neural network

Two-Stage Hybrid Model for Efficiency Prediction of Centrifugal Pump

Automatic optimization of centrifugal pump for energy conservation and efficiency enhancement based on response surface methodology and computational fluid dynamics

Numerical Simulation on Internal Flow in the Screw Centrifugal Pulp Pump

Hybrid model for discharge flow rate prediction of reciprocating multiphase pumps.

Multistage hybrid model for performance prediction of centrifugal pump

A New Prediction Method for the Complete Characteristic Curves of Centrifugal Pumps

Investigation on Inner Flow Quality Assessment of Centrifugal Pump Based on Euler Head and Entropy Production Analysis

Computational Fluid Dynamics-Based Pump Redesign to Improve Efficiency and Decrease Unsteady Radial Forces

Theoretical Model of Energy Performance Prediction and BEP Determination for Centrifugal Pump As Turbine