Abstract:The global energy shortage is gradually intensifying. A pump is a versatile device with significant power consumption in energy conversion equipment. Of the world's total energy generated, pumps consume about 20%. With the continuous expansion of the application field, the pump's transient working characteristics are increasingly getting important for energy saving and consumption reduction. Due to ignoring the influence of impeller rotational acceleration and fluid inertia, traditional methods have significant errors in predicting transient energy conversion characteristics, which leads to improper design and unreasonable lectotype, resulting in low pump operation efficiency. Improving the prediction accuracy of transient energy characteristics and ultimately improving the pump operation efficiency is considered to be the key solution to reducing energy consumption. Therefore, this research paper proposes a prediction model of transient energy characteristics in a mixed-flow pump. Firstly, the dynamic hydraulic torque, an important parameter of energy growth during the start-up process was calculated according to the momentum moment equation. Secondly, based on the torque energy balance equation and the relative Bernoulli equation, the transient head expression during the start-up process of the mixed-flow pump is derived, and the saddle area correction is carried out. Finally, considering the additional shaft power loss caused by the pump's backflow and clearance leakage flow, a calculation method for the instantaneous energy conversion efficiency of the mixed-flow pump is established. The accuracy of the model is compared with traditional quasi-steady-state calculation results. The results show that the predicted head of the model is in good agreement with the test head, the head estimation error is reduced from 15% to 5%, and the modified head in the saddle area is closer to the test value. In addition, this study also shows the ability of the model to simulate different start-up modes and start-up times. The models presented in this paper help guide the transient hydraulic design and prediction of transient energy characteristics of pumps.

Hybrid model for discharge flow rate prediction of reciprocating multiphase pumps.

Probabilistic Modeling and Prediction of Dynamic Discharge Process in Multiphase Pumps

Two-Stage Hybrid Model for Efficiency Prediction of Centrifugal Pump

Multistage hybrid model for performance prediction of centrifugal pump

Active Learning for Modeling and Prediction of Dynamical Fluid Processes

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Whole flow field performance prediction by impeller parameters of centrifugal pumps using support vector regression

Hydraulic Optimization of Super-low Specific Speed Multistage Flameproof Submersible Pump with Inner Motor for Coal Mine

Construction of Solid−Liquid Two−Phase Flow and Wear Rate Prediction Model in Multiphase Pump Based on Mixture Model−Discrete Phase Model Combination Method

Prediction model for energy conversion characteristics during transient processes in a mixed-flow pump

A Hybrid Lumped Parameters/Finite Element/Boundary Element Model to Predict the Vibroacoustic Characteristics of an Axial Piston Pump

Multiphase Flow Modeling Using Process Knowledge Integrating Temporal Graph Convolution Network

Research on Load Prediction of Low-Calorific Fuel Fired Gas Turbine Based on Data and Knowledge Hybrid Model

A Fault Detection Method for a Practical Electro-Hydraulic Variable-Displacement Pump with Unknown Swashplate Moment.

Theoretical and Simulation Investigations on Flow Ripple Reduction of Axial Piston Pumps Using Nonuniform Distribution of Pistons

Integrated probabilistic modeling method for transient opening height prediction of check valves in oil-gas multiphase pumps

Energy performance prediction of the centrifugal pumps by using a hybrid neural network

Towards Predictive Maintenance of a Heavy-Duty Gas Turbine A New Hybrid Intelligent Methodology for Performance Simulation

Introducing machine learning and hybrid algorithm for prediction and optimization of multistage centrifugal pump in an ORC system

The identification of gas–liquid two-phase flow patterns in a centrifugal pump with an imbalanced sample and variable rotational speeds

Influence of turbulence model on performance prediction of mixed-flow pump