Abstract:Accurate detection of the internal decomposition components of SF6 electrical equipment plays an important role in the evaluation of equipment status. However, gas samples are usually taken out for detection at present, which makes it difficult to understand the real situation inside the equipment. In this paper, a carbon nanotube-coated fiber gas sensor is proposed, which has the potential to be applied as a built-in gas sensor. The fiber loop ring-down (FLRD) gas detection system based on the carbon nanotube-coated fiber gas sensor was built, and the detectable decomposition components among the four typical SF6 decomposition components of SO2, SO2F2 and SOF2 and CO were analyzed. The results showed that the fiber gas sensor was most sensitive to CO. Based on density functional theory, it was found that single-walled carbon nanotubes had the best adsorption effect on CO molecules under the same conditions, with the adsorption energy reaching −0.150 Ha. The detection performance of the system for CO was studied, and the results showed that there was a good linear relationship between CO concentration and ring-down time: R2 was 0.984, the maximum inversion error of 0~200 ppm CO was 1.916 ppm, and the relative error was 4.10%. The sensitivity of the system was 0.183 ns/ppm, and the detection limit of the system was 19.951 ppm. The system had good stability, with the standard deviation of single-point repeatability being 0.00356, and the standard deviation of the long period of the experiment being 0.00606. The research results provide a new idea for the detection of SF6 decomposition components, and lay the foundation for the component detection method of built-in fiber sensor of SF6 electrical equipment.

Carbon monoxide gas sensor based on Co/Ni-MOF-74 coated no-core-fiber Michelson interferometer

Ni-MOF-74 film coated optical microfiber CO sensor cascaded with spiral fiber grating temperature compensator

Integration of a Metal-Organic Framework Film with a Tubular Whispering-Gallery-Mode Microcavity for Effective CO<sub>2</sub> Sensing

Lab-on-Fiber Fabry–Perot Interferometer Integrated With Functionalized Polymer for Carbon Dioxide Sensing

Integration of a Metal–Organic Framework Film with a Tubular Whispering-Gallery-Mode Microcavity for Effective CO 2 Sensing

Carbon Monoxide Detection Based on the Carbon Nanotube-Coated Fiber Gas Sensor

Photothermal CO Detection in a Hollow-Core Negative Curvature Fiber.

Sensitive Carbon Monoxide Detection Based on Light Induced Thermoelastic Spectroscopy with a Hollow Waveguide and 2.3 Μm Diode Laser

Improved Sensitivity of α-Fe2O3 Nanoparticle-Decorated ZnO Nanowire Gas Sensor for CO

CuO surface doped In2O3/CeO2 nanofibers for ppb-ppm level carbon monoxide gas detection in low-temperature

Bimetallic Two-Dimensional Metal-Organic Frameworks for the Chemiresistive Detection of Carbon Monoxide

MOF-derived Co3O4 nanoparticles over direct grown ZnO nanoflower on ceramic for CO sensor with high selectivity

Sensitive carbon monoxide detection based on laser absorption spectroscopy with hollow‐core antiresonant fiber

Fiber-optic Michelson interferometric trace dimethyl methyl phosphate sensor based on MnO2/ZnO composites film

Fabrication and Analysis of a Gas Sensor Utilizing a Fabry–Perot Interferometer With Varied Thicknesses of ZIF-8 Coating on End-Faced Single-Mode Optical Fiber

Highly sensitive hybrid nanofiber-based room-temperature CO sensors: Experiments and density functional theory simulations

Sub-ppm CO Detection in a Sub-Meter-long Hollow-Core Negative Curvature Fiber Using Absorption Spectroscopy at 2.3 Μm

Selective detection of trace carbon monoxide at room temperature based on CuO nanosheets exposed to (111) crystal facets

Low concentration CO gas sensor constructed from MoS2 nanosheets dispersed SnO2 nanoparticles at room temperature under UV light

Cu-MOF-74-derived Cu2O/CuO-C nanocomposite as an effective chemiresistive sensor for detection of NO2 at room temperature

Carbon Monoxide (CO) Sensor Based on Au Nanoparticles Embedded in a CuO Matrix by HR-LSPR Spectroscopy at Room Temperature