Abstract:Titanium alloys show excellent thermal mechanical and chemical properties, which meet the practical needs in the area of astronautic, aeronautic and navigational industries. However the very difficult machinability becomes the main obstacle for their further application. The available high speed cutting technology exhibits the good prospect for obtaining satisfied surface integrity and good chip formation control. The recent researches on chip formation mechanism and surface integrity generation mechanism based on plasticity deformation analysis and the systematical experimental tests of milling process characteristics were conducted and presented in this paper. Some basic factors such as the end milling cutter tooth number, cutting forces, cutting temperature, the chip status, the surface roughness, the hardness distribution and the metallographic texture of the machined surface layer were involved. The optimal technologies of high speed milling titanium alloys have been developed. The paper revealed some interesting phenomena on chip formation mechanism and surface integrity as well as milling process characteristics of titanium alloy in high speed milling, which were greatly different from that of conventional case. The chip formation mechanism is typical thermal plastic shear localization at high cutting speed with less number of shear ribbons and bigger shear angle than that at low speed, which means lack of chip deformation. The high cutting speed with much more cutting tooth will be beneficial to reduction of cutting forces, enlarge machining stability region, depression of temperature increment, auti-fatigability as well as surface roughness. The burrs always exist both at low cutting speed and at high cutting speed. So the deburr process should be arranged for milling titanium alloy in any case. The hints of the investigation will be beneficial to the development of the new type cutting tools and milling surface quality control. With the optimal technologies of high speed milling titanium alloys, the great production efficiency can be available and the very good surface integrity of the titanium alloy can also be guaranteed.

Experimental Research on Chip Morphology of Ti-5553 Cutting under High-Pressure Cooling

Experiment and numerical study of chip formation mechanism during cryogenic machining of Ti-6Al-4V alloy

Reaserch on Mechanism and Experimental of Chip Breaking During High Pressure Cooling Turning of Superalloys with PCBN Tool

Correction of the constitutive model and analysis of chip formation in cryogenic machining of TA15 titanium alloy

Effect of cutting conditions on the serrated chip formation in high-speed cutting

Tool Wear and Surface Integrity of γ-TiAl Cryogenic Coolant Machining at Various Cutting Speed Levels

Surface Integrity Analysis for High-Pressure Jet Assisted Machined Ti-6Al-4V Considering Cooling Pressures and Injection Positions

Experimental study on fracture mechanism transformation in chip segmentation of Ti-6Al-4V alloys during high-speed machining

Analysis of Chip Morphology in Heavy Milling of 508III Steel Considering Different Tool Wear Conditions

Investigation of Chip Formation Mechanism and Surface Integrity in High Speed Milling Titanium Alloy

Experimental Study on the Optimization of Ti1023 Milling Parameters

Simulation of Chip Formation in High-Speed Hard Machining

Study on the reaming process of aluminum alloy 7050-T7451 under different cooling conditions

Investigation on Morphological Evolution of Chips for Ti6Al4V Alloys with the Increasing Milling Speed

Experimental study on machining properties of a high-strength composite material with Ti-555 titanium alloy matrix

Research on Cutting Layer Characteristics of Superalloy under High-Pressure Cooling

Experimental Study on the Surface Integrity and Chip Formation in the Micro Cutting Process

Large Chip Production Mechanism under the Extreme Load Cutting Conditions

Effect of morphological evolution of serrated chips on surface formation during high speed cutting Ti6Al4V

Tough-brittle transition mechanism and specific cutting energy analysis during cryogenic machining of Ti–6Al–4V alloy

Tool wear analysis of cutting Ti-5553 with uncoated carbide tool under liquid nitrogen cooling condition using tool wear maps