Enhancing tensile strength of Mg–Al–Ca wrought alloys by increasing Ca concentration
Qiuyan Huang,Yang Liu,Min Tong,Hucheng Pan,Changlin Yang,Tianjiao Luo,Yuansheng Yang
DOI: https://doi.org/10.1016/j.vacuum.2020.109356
IF: 4
2020-07-01
Vacuum
Abstract:<p>The tensile strengths of the as-extruded Mg–Al–Ca ternary alloys at both ambient and elevated temperatures are enhanced via adding a high content of Ca element up to 6 wt%. High-temperature strength of the present rare-earth-free Mg alloys can be even compared with those of the reported Mg-RE alloys. The as-extruded Mg–6Al–6Ca (wt. %, AX66) alloy exhibits a tensile yield strength (YS) of ∼404 MPa and an ultimate tensile strength (UTS) of ∼415 MPa at room temperature, and YS of ∼225 MPa and UTS of ∼265 MPa at 200 °C, respectively. For the AX66 alloy, the nucleation rates of dynamic recrystallized (DRXed) grains are larger than those of the AX62 and AX64 alloys due to the typical particle stimulated nucleation effect. A number of long-rod Al<sub>2</sub>Ca phase is dispersed at the grain boundaries of AX66 alloy, and a restricted degree of DRX is induced. Consequently, the majority ofα-Mg matrix exists in the as-deformed state involving a high density of subgrains. The combined effects of grain refinement hardening, texture hardening and precipitation hardening guarantee the high strength. Specially, numerous micron-scale bulk (Mg, Al)<sub>2</sub>Ca phases are found to distribute among matrix, which play a critical role in maintaining the high thermal-resistance.</p>
materials science, multidisciplinary,physics, applied