Evaluation of Zirconia Surface Roughness after Different Surface Treatment with Sandblasting, Hydrofluoric Acid Etching, and Combination Treatment

Novi Sagita Rizky,Rasmi Rikmasari,Setyawan Bonifacius

DOI: https://doi.org/10.4028/p-46wccw

2022-09-20

Key Engineering Materials

Abstract:Publication date: 20 September 2022 Source: Key Engineering Materials Vol. 932 Author(s): Novi Sagita Rizky, Rasmi Rikmasari, Setyawan Bonifacius Zirconia is one of the materials used in prosthetic restoration because of its better physical, mechanical, chemical, and biological properties. The surface treatment for zirconia can be mechanical, with grinding, sandblasting, and laser or chemically, with silane and etching. The combination of chemical and mechanical surface treatment can increase the surface roughness so that the bonding with the resin cement also increases. The study aims to examine the zirconia surface roughness after different surface treatments. This study used 25 zirconia samples in 10x10x2 mm square-shaped, divided into five groups. Group 1 treats sandblasting as a control. Group 2 sandblasting then etching with 9.5% hydrofluoric acid at 25°C for 60 minutes. Group 3 sandblasting then etching with 9.5% hydrofluoric acid at 100°C for 1 minute. Group 4 etching with 9.5% hydrofluoric acid at 25°C for 60 minutes. Group 5 etching with 9.5% hydrofluoric acid at 1000C for 1 minute. The samples were cleaned with an ultrasonic cleaner and tested using a profilometer. The data test by using the ANOVA test and T-test. The highest surface roughness was the combination of sandblasting with 9.5% hydrofluoric acid etching at 25°C for 60 minutes. The lowest was 9.5% hydrofluoric acid etching at 100°C for 1 minute. ANOVA statistical analysis with a p-value <0.05 ((8.4051 x 10-12) indicates that the test was significant. The result of this study was the combination of surface treatments resulted in higher surface roughness. Duration of the etching time affected the increase of zirconia surface roughness.