Abstract:Bridge weigh-in-motion (BWIM) technology, which identifies traffic information such as the axle weights, wheelbases, and velocities of vehicles passing over a bridge from bridge responses, can be beneficial for bridge design, management, and maintenance. However, conventional BWIM methods simplified the coaxial wheel loads of a vehicle using one concentrated force, commonly known as the axle load. Such simplification would lead to two problems. Firstly, it fails to calculate the wheel weights of moving vehicles, which are essential for evaluating the service status of roads and is required to be measured by national weigh-in-motion specifications, such as ASTM E1318-09. Secondly, the transverse distance between the coaxial wheels (track width), and unequal load distributions between left and right coaxial wheels (unbalance) were ignored in the conventional BWIM methods. However, these two factors represented the actual characteristics of the vehicle load applied on the bridge. Hence, ignoring these two factors could lead to significant errors in estimating the vehicle weight when the track width or the unbalance ratio of the test vehicle was different from that of the calibration vehicle. To address the above two problems, this study proposed a new BWIM method, where two concentrated loads with fixed transverse distance were used to represent the coaxial wheel loads of the truck in analyzing the interactions between the truck and the bridge. By doing so, the wheel weights of moving vehicles can be calculated, and both the effects of the unbalance and the track width can be considered in estimating the axle weights of the vehicle. Both experiment results and simulation results demonstrated that the proposed method can effectively identify the wheel weights of moving vehicles, and provide more accurate axle weights than conventional BWIM methods under complex traffic scenarios.

How to Use BWIM Data in Fatigue Evaluation of a Medium-span Steel Bridge

Site-Specific Fatigue Load Spectrum for Urban Bridges

Fatigue Performance Assessment of Composite Arch Bridge Suspenders Based on Actual Vehicle Loads

Statistical Analysis of Site-specific Traffic Load Using Weigh-in-Motion Data

FE-based Bridge Weigh-in-motion Based on an Adaptive Augmented Kalman Filter

Investigation of the Fatigue Stress of Orthotropic Steel Decks Based on an Arch Bridge with the Application of the Arlequin Method

Wavelet domain analysis for identification of vehicle axles in the application of BWIM technology

Bridge Vehicle Load Model on Different Grades of Roads in China Based on Weigh-in-Motion (WIM) Data

Incorporating Site-Specific Weigh-in-motion Data into Fatigue Life Assessment of Expansion Joints under Dynamic Vehicle Load

A BWIM Method Used for Steel Truss Bridges

Vehicle models for fatigue loading on steel box-girder bridges based on weigh-in-motion data

Fatigue Performance Evaluation for an Orthotropic Steel Bridge Deck Based on Field Hotspot Stress Measurements

WIM-based vehicle load models for urban highway bridge

Fatigue Reliability Analysis of a Suspension Bridge Using Long-Term Monitoring Data

Using Statistical Analysis of an Acceleration-Based Bridge Weigh-In-Motion System for Damage Detection

Hot Spot Stress Approach For Fatigue Life Assessment In Welded Bridge Connections Using Monitoring Data And Fem Analysis

Fatigue Evaluation of Steel Bridge Details Integrating Multi-Scale Dynamic Analysis of Coupled Train-Track-Bridge System and Fracture Mechanics

A computer vision-assisted method for identifying wheel loads of moving vehicles from dynamic bridge responses

Monitoring-Based Fatigue Reliability Assessment of Steel Bridges: Analytical Model and Application

Statistical Analysis of Stress Spectra for Fatigue Life Assessment of Steel Bridges with Structural Health Monitoring Data

Study On Fatigue Traffic Loading For Highway Bridges In China