Abstract:Activated carbons (ACs) have been the most widespread carbon materials used in supercapacitors (SCs) due to their easy processing methods, good electrical conductivity, and abundant porosity. For the manufacture of electrodes, the obtained activated carbon based on sawdust (karagash and pine) was mixed with conductive carbon and polyvinylidene fluoride as a binder, in ratios of 75% activated carbon, 10% conductive carbon black, and 15% polyvinylidene fluoride (PVDF) in an N-methyl pyrrolidinone solution, to form a slurry and applied to a titanium foil. The total mass of each electrode was limited to vary from 2.0 to 4.0 mg. After that, the electrodes fitted with the separator and electrolyte solution were symmetrically assembled into sandwich-type cell construction. The carbon's electrochemical properties were evaluated using cyclic voltammetry (CV) and galvanostatic charge-discharge (CGD) studies in a two-electrode cell in 6M KOH. The CV and CGD measurements were realized at different scan rates (5-160 mV s-1) and current densities (0.1-2.0 A g-1) in the potential window of 1 V. ACs from KOH activation showed a high specific capacitance of 202 F g-1 for karagash sawdust and 161 F g-1 for pine sawdust at low mass loading of 1.15 mg cm-2 and scan rate of 5 mV s-1 in cyclic voltammetry test and 193 and 159 F g-1 at a gravimetric current density of 0.1 A g-1 in the galvanostatic charge-discharge test. The specific discharge capacitance is 177 and 131 F g-1 at a current density of 2 A g-1. Even at a relatively high scan rate of 160 mV s-1, a decent specific capacitance of 147 F g-1 and 114 F g-1 was obtained, leading to high energy densities of 26.0 and 22.1 W h kg-1 based on averaged electrode mass. Surface properties and the porous structure of the ACs were studied by scanning electron microscopy, energy-dispersive X-ray analysis, Raman spectroscopy, and the Brunauer-Emmett-Teller method.

High-surface-area activated carbon from pine cones for semi-industrial spray deposition of supercapacitor electrodes

Pine Sawdust Derived Ultra-High Specific Surface Area Activated Carbon: Towards High-Performance Hydrogen Storage and Supercapacitors

High Performance Supercapacitors Electrode Derived from the Pine Needles

Control of Nano Grains and Wide Carbocyclic Layer Space of Forming Active Carbon with Extraordinary Capacitance Characteristics in Supercapacitors

Renewable pine cone biomass derived carbon materials for supercapacitor application

Hydrangea-like N/O codoped porous carbons for high-energy supercapacitors

Aqueous Activated Graphene Dispersions for Deposition of High-Surface Area Supercapacitor Electrodes

Pinecone biomass‐derived activated carbon: the potential electrode material for the development of symmetric and asymmetric supercapacitors

Facile Synthesis of Nitrogen Self-Doped Hierarchical Porous Carbon Derived from Pine Pollen Via MgCO3 Activation for High-Performance Supercapacitors

Green synthesis of porous carbon for supercapacitors from pine cone/phoenix tree fruit fluff by hydrothermal pre-activation method

Porous Carbon derived from Pine Nut Shell prepared by Steam Activation for Supercapacitor Electrode Material

Surface Modification by Graphene Oxide: an Efficient Strategy to Improve the Performance of Activated Carbon Based Supercapacitors

Improving the rate capability of microporous activated carbon-based supercapacitor electrodes using non-porous graphene oxide

Activated Biomass-derived Graphene-based Carbons for Supercapacitors with High Energy and Power Density

Investigation of Hybrid Electrodes of Polyaniline and Reduced Graphene Oxide with Bio-Waste-Derived Activated Carbon for Supercapacitor Applications

Pine Needle-Derived Microporous Nitrogen-Doped Carbon Frameworks Exhibit High Performances in Electrocatalytic Hydrogen Evolution Reaction and Supercapacitors.

Carbon electrode material from peanut shell by one-step synthesis for high performance supercapacitor

Nature-inspired Self-Activation Method for the Controllable Synthesis of Highly Porous Carbons for High-Performance Supercapacitors

Sustainable activated carbons from dead ginkgo leaves for supercapacitor electrode active materials

Cellulose-Solvent-Assisted, One-Step Pyrolysis to Fabricate Heteroatoms-Doped Porous Carbons for Electrode Materials of Supercapacitors

Electrochemical Performance of Chemically Activated Carbons from Sawdust as Supercapacitor Electrodes