Abstract:For plain carbon steels, the microduplex (alpha + theta) structure consisting of ultrafine ferrite matrix and dispersed cementite particles demonstrates a good balance between strength and ductility as compared with a normal microstructure, e.g. ferrite plus pearlite in hypoeutectoid steels or pearlite in eutectoid steels etc.. Various thermo-mechanical treatments have been developed to obtain such microduplex (alpha + theta) structure. It is commonly considered that the formation of fine equiaxed ferrite grains during thermo-mechanical treatments involving hot (warm) deformation could be attributed to dynamic recrystallization (DRX) of ferrite. However, the mechanism of DRX of ferrite during the formation of the microduplex (alpha + theta) structure as well as the effect of cementite particles on DRX of ferrite are still not well understood. In the present work, DRX of ferrite in a medium-carbon steel with different tempered martensites was investigated by hot uniaxial compression tests at 0.01 s(-1) and 700 degrees C, and the effect of cementite particles with different initial states was analyzed. The results indicate that during hot deformation the coarsening of cementite particles and DRX of ferrite took place, leading to the formation of the microduplex (alpha + theta) structure. In comparison with static tempering, the diffusions of Fe atoms and C atoms were enhanced by hot deformation and thus the coarsening kinetics of cementite particles was accelerated by 2-3 orders of magnitude. During hot deformation the sizes of cementite particles at the boundaries of ferrite grains increased and the amount of cementite particles in ferrite grains decreased. The former is beneficial to the particle stimulated nucleation under coordinated effects of several particles, and the later can reduce the drag effect of cementite particles on the migration of grain boundaries, both of them are advantageous to DRX of ferrite. With the decrease in the size of cementite particles in the initial microstructures, the critical strain for DRX of ferrite increased, but the resultant microduplex (alpha + theta) structure is fine, and more uniform.

Structure Formation of the Nitrogen-Containing Austenitic 04Kh20N6G11M2AFB Steel at Hot Deformation: Part II. Influence of the Phase Composition and Conditions of Hot Deformation on the Process of Dynamic Recrystallization

Research on the thermal plasticity of the 18Mn-18Cr-0.77N-2Mo high nitrogen austenitic stainless steel

Study of High-Strength Austenitic Nitrogen-Containing Steel Ingot Phase Formation and Structure

Dynamic recrystallization of ferrite during deformation at temperatures below A(c1) in a low carbon steel

Hot Deformation Behavior of a New Austenite–ferrite Duplex Stainless Steel Containing High Content of Nitrogen

Effect of the Temperature of Shock-Wave Loading on Structure and Phase Transformations in Nitrogen-Containing Austenitic Cr–Mn–Ni Steel

Constitutive Modeling and Dynamic Softening Mechanism During Hot Deformation of an Ultra-Pure 17%cr Ferritic Stainless Steel Stabilized with Nb

Hot Deformation Behavior and Processing Map of Cr–Mn–Ni–Mo–N Austenitic Stainless Steels

Studies on Hot Deformation Behavior and Dynamic Recrystallization in a High Al Ferritic Low-Density Steel

Carbonitride Dissolution And Austenite Grain Growth In A High Cr Ferritic Heat-Resistant Steel

On Microstructure Characterization of Fe–Cr–Ni–Mo–N Super-Austenitic Stainless Steel During Hot Deformation

Grain Refining Behavior by Dynamic Recrystallization of As-Forged Austenitic Stainless Steel with High N

Inversion of Nitrogen Redistribution in Austenitic Steel by Severe Plastic Deformation

Microstructural evolution during the austenite-to-ferrite transformation from deformed austenite

Investigation of the Hot Deformation Behavior of 22Cr‐25Ni Austenitic Heat‐Resistant Steel by Combining Constitutive Model and Processing Map

Dynamic recovery and recrystallization mechanisms in secondary B2 phase and austenite matrix during hot deformation of Fe–Mn–Al–C-(Ni) based austenitic low-density steels

Research on the Phase Transformation of a Newly Developed Carbonitride-Strengthened Martensitic Heat Resistant Steel

Study on Recrystallization Initiation Model and Microstructure Evolution Mechanism of 18CrNimo7-6 Steel During Hot Deformation

DYNAMIC RECRYSTALLIZATION OF FERRITE IN A MEDIUM-CARBON STEEL WITH TEMPERED MARTENSITE STRUCTURE DURING HOT DEFORMATION

Effect of non-isothermal deformation of austenite on ferrite transformation behavior studied by in-situ neutron diffraction

A Study of Decomposition of Supercooled Austenite in High-Strength Medium-Carbon Complexly Alloyed Cold-Resistant Steels