Study on rheological properties of natural gas hydrate slurry

Xiaofang Lv,Boyu Bai,Yi Zhao,Yang Liu,Qianli Ma,Chuanshuo Wang,Shidong Zhou,Shangfei Song,Bohui Shi

DOI: https://doi.org/10.1016/j.cherd.2022.10.024

IF: 4.119

2022-12-01

Chemical Engineering Research and Design

Abstract:The environmental conditions of high pressure and low temperature in deep water have brought serious challenges to the safe operation of oil–gas mixture transportation in pipeline due to hydrate blockage. This paper was focused on the effects of water cut, polymerization inhibitor concentration, and temperature on the viscosity of natural gas hydrate slurry, and established the a rheological model of hydrate slurry with the help of a high-pressure reactor and a rheometer. The results showed that the increase in water cut could significantly improve the apparent viscosity of hydrate slurry. The apparent viscosities were 20 mPa s at 30% water cut and about 15 mPa s at 15% water cut. The increase in polymerization inhibitor concentration would also increase the apparent viscosity of the slurry. When the concentration of polymerization inhibitor increased from 0 wt% to 3 wt%, the slurry viscosity was increased by 4.9%. As for the temperature, the apparent viscosity of the slurry was inversely proportional to the temperature. When the temperature increased from 3 °C to 5 °C, the viscosity was decreased by 5.9%. The sensitivity analysis showed that the water cut had the greatest influence on the apparent viscosity. In addition, the natural gas hydrate slurry showed typical shear dilution in the experimental system. According to the viscosity characteristics of hydrate slurry in the high-pressure reactor system, an empirical prediction model based on Camago–Palermo model was established. The predicted value from the model had an error less than 3.5% comparing to the experimental value, which meant that the model had a high accuracy.