Abstract:Dry reforming of methane (DRM) is a feasible route to realize the resource utilization of greenhouse gases CO2 and CH4. The Ni-based catalyst is recognized as a potential catalyst for the industrialization of DRM. However, catalyst deactivation caused by carbon deposition is a challenge. Providing enough active oxygen species to accelerate the reaction between CH x (x = 0–3) and oxygen species is the key to inhibit coking. Ni-based catalysts loaded on a Zr-doped Ce1–x Zr x O2 nanorod were prepared by a one-step hydrothermal method. Benefiting from lattice distortion caused by Zr doping, the Ni/Ce0.95Zr0.05O2 catalyst showed the best catalytic activity and stability. Compared with the Ni/CeO2 catalyst, the activation energy of CH4 and CO2 decreased by 20 and 22%, respectively. The 100 h stability test showed that the Ni/CeO2 catalyst was 10% deactivated, and the carbon deposition rate was 0.82 mgc·gcat·–1·h–1, while the Ni/Ce0.95Zr0.05O2 catalyst showed excellent stability. The extensive characterization of the catalysts indicated that the enhancement in DRM activity upon Zr doping could be attributed to the increase of oxygen vacancies and the improvement in lattice oxygen mobility. However, excessive Zr doping formed ZrO2 covering oxygen vacancies, resulting in decreased catalytic activity and stability. The results showed that lattice oxygen over the Ni/Ce0.95Zr0.05O2 catalyst not only participated in the oxidation of carbon intermediates but also contributed to the deep dissociation of CH4 over Ni through an oxygen-mediated dissociation pathway. Similarly, the redox cycle on the oxygen vacancies was also important for enhancing the CO2 adsorption activation to relieve the coking of the catalyst.

Engineering the oxygen vacancies enables Ni single-atom catalyst for stable and efficient C-H activation

Engineering MOx/Ni Inverse Catalysts for Low-Temperature CO2 Activation with High Methane Yields

Transition Metal (Fe, Zn, Co, and Ni) Single-Atom Catalysts Anchored on N,S-Codoped Hybrid Nanocarbons for Oxygen Reduction Reaction

Engineering a Nickel–Oxygen Vacancy Interface for Enhanced Dry Reforming of Methane: A Promoted Effect of CeO2 Introduction into Ni/MgO

Ni/CeO2 Catalyst Prepared via Microimpinging Stream Reactor with High Catalytic Performance for CO2 Dry Reforming Methane

Lamellar cross-linking Ni/CeO 2 as an efficient and durable catalyst for dry reforming of methane

Stabilizing Ni catalysts in biogas reforming via in situ carbon deposit removal by CeO2 oxygen vacancies

Preparing a Zr-Doped CeO 2 Nanorod to Improve the Catalytic Performance of the Ni-Based Catalyst for Dry Reforming of Methane by Enhancing Oxygen Supply

Boosting Oxygen Vacancy Formation and Ni Dispersion by Ce0.9Y0.1O2 Nanorod: Efficient Water and Hydrocarbon Activation

Ceria engineering in nickel catalysts to improve CH 4 selectivity and yield for CO methanation

Modulation of oxygen-etching for generating nickel single atoms for efficient electroreduction of CO2 to syngas (CO/H2)

Ultrastable Nickel Single-Atom Catalysts with High Activity and Selectivity for Electrocatalytic CO2 Methanation

Highly active Ni/CeO2/SiO2 catalyst for low-temperature CO2 methanation: Synergistic effect of small Ni particles and optimal amount of CeO2

Highly efficient and stable Ni/CeO2-SiO2 catalyst for dry reforming of methane: Effect of interfacial structure of Ni/CeO2 on SiO2

Highly active Ni/CeO2 catalyst for CO2 methanation: Preparation and characterization

Improving the anti-coking ability in the Ni-M(M = Ce, Zr, Co)@SiO 2 yolk-shell catalysts for dry reforming of methane

The Ga-promoted Ni/CeO2 catalysts for dry reforming of methane with high stability induced by the enhanced CO2 activation

Improved Selectivity and Stability in Methane Dry Reforming by Atomic Layer Deposition on Ni-CeO 2 -ZrO 2 /Al 2 O 3 Catalysts

Improving the Anti-Coking Ability in the Ni-M(M = Ce, Zr, Co)@SiO2 Yolk-Shell Catalysts for Dry Reforming of Methane

CO2 Methanation on the Catalyst of Ni/MCM-41 Promoted with CeO2

Ni/Ce0.9Eu0.1O1.95 with enhanced coke resistance for dry reforming of methane