Abstract:Emerging applications of robots with direct physical interactions with humans have led to the development of a variety of series elastic actuators (SEAs) which are compliant, force controllable, and back drivable. The performance of current SEAs is mainly dependent on the specific stiffness of the spring. In our previous work, a compliant actuator with two-stage stiffness has been designed to overcome the performance limitations in current SEAs. The key novelty is that a low-stiffness spring and a high-stiffness spring are employed instead of a single spring in current SEAs, which has the advantages of high fidelity, low output impedance, and also large force range and bandwidth. In this paper, a tracking control scheme is proposed for the compliant actuator with two-stage stiffness. Although the overall stiffness is discontinuous, the proposed controller is continuous by integrating different control modes for two springs into a single one. The transition between control modes is smooth and embedded inside the controller, and it is also automatically realized by monitoring the output force of the actuator. The stability and convergence of the closed-loop system are analyzed, and experimental results are presented to demonstrate the effectiveness of the proposed control scheme.Note to Practitioners—An SEA is developed by placing an elastic element into the actuator; this elasticity gives SEAs several unique properties including low mechanical output impedance, tolerance to impact loads, and passive mechanical energy storage, which makes it suitable for human–robot interaction. The performance of existing SEAs is highly dependent on the stiffness of a single spring. To overcome the limitations, a novel SEA with two-stage stiffness was proposed in our previous work. This paper suggests a continuous tracking control method for the proposed compliant actuator. Although the overall stiffness is discontinuous, the transition between different control modes for two springs is smooth and automatically realized. Experimental results show that the output force of the actuator is bounded. In future research, uncertainties in actuator dynamics will be considered, such that system identification or calibration is not required.

Design, modeling, and control of a Series Elastic Actuator with Discretely Adjustable Stiffness (SEADAS)

Design and Control of a Novel Variable Stiffness Series Elastic Actuator

Novel series elastic actuator design and velocity control

An adaptive compliance position control based on EKF for series elastic actuation

Electromechanical Model-Based Adaptive Control of Multilayered Dielectric Elastomer Bending Actuator

Design and Control of an Electrohydraulic Soft Actuator System for Robotic Grippers

Modelling and Control of a Dielectric Elastomer Actuator

Design and Control of a Series Elastic Actuator with Clutch for Hip Exoskeleton for Precise Assistive Magnitude and Timing Control and Improved Mechanical Safety

Design, Modelling and Control of Novel Series-Elastic Actuators for Industrial Robots

Conceptual Design, Modeling and Control of a Rigid Parallel Serial-Elastic Actuator

Optimally Controlling the Timing of Energy Transfer in Elastic Joints: Experimental Validation of the Bi-Stiffness Actuation Concept

Design and Research of Series Actuator Structure and Control System Based on Lower Limb Exoskeleton Rehabilitation Robot

Design of Series Elastic Actuator for the Knee Joint of Assistive Limb

Design and Analysis of a Clutched Parallel Elastic Actuator

Interconnection and Damping Assignment Passivity-Based Impedance Control of a Compliant Assistive Robot for Physical Human–Robot Interactions

Design and Control of a Discrete Variable Stiffness Actuator With Instant Stiffness Switch for Safe Human-Robot Interaction

Design and Control of a Series Elastic Actuator with High Compliance for Serial Manipulators

Flexible Actuator with Variable Stiffness and Its Decoupling Control Algorithm: Principle Prototype Design and Experimental Verification

Design of a Series Elastic Actuator with Double-layer Parallel Spring for Lower Limb Exoskeletons.

Optimal Design of a Nonlinear Series Elastic Actuator for the Prosthetic Knee Joint Based on the Conjugate Cylindrical Cam.

Continuous Tracking Control for a Compliant Actuator with Two-Stage Stiffness