Abstract:The roughness of the road surface is one of the most important indicators of the pavement quality as-sessment.Based on the pavement quality assessment in the analysis of road roughness,this article designs the road roughness acquisition system based on the acceleration sensor.For the hardware part of the system,the sig-nal collecting module is developed with C805 1 F005 micro-controller that can measure vehicle vertical accelera-tion analog signal which is from negative one point two volts to one point two volts,and then it is adjusted to the appropriate signal range which is from zero to three point three volts of the input signal range of A/D conversion module.A/D converting digital signal is sent to the bluetooth by the UART serial port of the micro-computer, and then transmitted to the PC;the software part of the system adopts a method based on vehicle vertical acceler-ation time series auto-regressive (AR)modeling of international road roughness index (IRI)measurement.In other words,it uses the Kalman algorithm to filter the initial data,and then calculates power spectrum density (PSD)by AR model.After getting the road roughness coefficient,the road IRI can be calculated by the formu-la.We give the concrete implementation plan,analyze rationality of the scheme,and used the collection system developed to carry out the real vehicle road test.As is well known,concrete pavement and asphalt pavement are the most common type of urban roads,so this article finally decides to collect two roads of Zhenjiang district which are asphalt pavement and cement concrete pavement.After test,we found that the IRI of Xuefu road was 2.593,and the IRI of Qingfen road was 1.954,and both of them were A level road.At the same time,we used high accurate laser surface flatness cytometry to do a comparative test.The experimental results showed that the scheme proposed had small errors and was consistent with realistic conditions.At the same time,it also proved that the design of road surface acquisition hardware device was reasonable and effective,and this system could be applied to engineering road detection and classification and some other related areas.

Use of Cellphone Application to Measure Pavement Roughness

Comparison of Smartphone-Based and Drone-Based Approaches for Assessing Road Roughness

An Experiment on Measurement of Pavement Roughness via Android-Based Smartphones

Assessing and Mapping of Road Surface Roughness based on GPS and Accelerometer Sensors on Bicycle-Mounted Smartphones

Validation of smartphone based pavement roughness measures

Low cost ultrasonic roughometer for pavement roughness measurement

Pavement Roughness Evaluation for Urban Road Management

Testing & Evaluation of Road Bounce PRO-Mobile Phone App Based Technology for Road Measurement

Iri Estimation Using Analysis of Dynamic Tire Pressure and Axle Acceleration

Design of road roughness collecting system based on acceleration sensor

Estimating IRI based on pavement distress type, density, and severity: Insights from machine learning techniques

Feasibility study on measurement of a physiological index value with an electrocardiogram tester to evaluate the pavement evenness and driving comfort

An ensemble learning with sequential model-based optimization approach for pavement roughness estimation using smartphone sensor data

Measurement Through Dynamic Tire Pressure Sensor Inside the Tire

Estimation of road surface quality using real-time video analysis

Measurement of Pavement Unevenness and Evaluation Through the IRI Parameter – an Overview

Reconciling Pavement Condition Data from Connected Vehicles with the International Roughness Index from Standard Monitoring Equipment Using Physics-Integrated Machine Learning

Evaluating road surface conditions using dynamic tire pressure sensor

Development and Preliminary Evaluation of a Varying-Speed Road Profiler

Smartphone-Based Pavement Roughness Estimation Using Deep Learning with Entity Embedding

Low-Cost Portable Road Smoothness Testing Method Based on Pseudo-Vibration Velocity Range