Abstract:The residual stress reductions of metals enabled by external field treatments are of high industrial significance, such as pulsed magnetic treatment (PMT) and coupled electromagnetic treatment (CET). There still exist sophisticated issues regarding process comparison and mechanism. In the present work, both the PMT and the CET were used to reduce the residual stress in P10 carbide tools. Besides residual stress measurements and microscopic observations of dislocations in the tested tools, a new model for modelling dislocation interactions in the treated tools was developed to reveal more complex mechanisms of the microstructural changes induced by the external fields. The results obtained with the X-ray diffraction method demonstrated a 30% stress reduction with the PMT and a 65% reduction with the CET. The dislocation morphology observed with a Transmission Electron Microscope was examined on their characteristics, quantity, and distribution. It was suggested that the WC phase with the dislocation of multiple quantities and wide distribution could be obtained easily through the CET. Deformation displacements and directions, internal stresses and volume strains, calculated using a transient 3D model with COMSOL (Multiphysics software), were compared. It was quantitatively confirmed that the internal stress produced both the PMT and the CET could force the dislocation to move. Compared with the PMT, there was a mutation phenomenon of the stress magnitude and direction during the CET, which was more conducive to the dislocation multiplication and dislocation interaction. The proposed Opposite Sign Parallel Dislocation Interaction Model also showed that the interactions between dislocations could effectively reduce the lattice distortion at the severe distortion area of the dislocations. The study showed that the residual stress could be effectively reduced by the evenly enhanced dislocation stretching and compression asymmetry after dislocation multiplication.

Mechanism of Blunt Punching Tools’ Influence on Deformation and Residual Stress Distribution

Microstructure and texture evolution of nonoriented silicon steel during the punching process

Investigation on Wear-Induced Edge Passivation of Fine-Blanking Punch

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

A Method for Evaluating the Degradation of Edge Stretchability Incorporating Punching Damage Based on Marciniak and Kuczynski Model

Residual stress reductions of carbide cutting tools through applying pulsed magnetic field and coupled electromagnetic field – mechanism analysis and comparison study

Deformation field in deep flat punch indentation and the persistence of dead-metal zones

Study of fracture damage criteria and influence of process parameters on punching of hot stamped ultra-high strength steel

Interaction Effect of Cracks and Anisotropic Influence on Degradation of Edge Stretchability in Hole-Expansion of Advanced High Strength Steel

Finite Element Analysis of the Magneto-Mechanical Coupling Due to Punching Process in Electrical Steel Sheet

Effect of Stress-Temperature Coupling on Gradient Alloying Induced by Punching Severe Deformation

Numerical simulation of fine-blanking process using a mixed finite element method

Size Effect on the Punch Performance of Brittle Porous Ceramics: Theoretical Analysis and Numerical Simulation

Study on Influence Factors of Small Punch Test Based on Ductile Damage Numerical Analysis

Numerical and Experimental Investigations on Mechanical Trimming Process for Hot Stamped Ultra-High Strength Parts

Analytical modeling of milling residual stress under different tool wear conditions

Deformation Behavior of Curved Shells in Multi-Point Forming with Asymmetric Punches

An Investigation of Step-Shaped-punch Fine-Blanking Process Using Finite Element Method

Numerical and experimental investigation of tool geometry effect on residual stresses in orthogonal machining of Inconel 718

Theoretical and experimental investigation of the deformation shape in press-braking bending considering surface residual stresses induced by milling operation

Effect of punch type on microstructure and mechanical properties of aluminum alloy structures prepared by electromagnetic riveting