Abstract:This study aims to propose a model for dynamically simulating the online-refueling process in pebble-bed reactor (PBR) using MCNPX. PBR has a special feature of online-refueling which can greatly reduce the outage time and enable a higher burnup in spent fuel. However, this feature also results in the dynamical fuel movements which may significantly increase the difficulty and the computational time in computer simulation. Therefore, an appropriate model is necessary to be proposed to simulate the burnup characteristics of online-refueling and to reduce the computational time simultaneously. All the calculations in this study were performed using MCNPX 2.7.0 with the ENDF/B-VII continuous energy nuclear data library. The PBR model was built according to the core design of HTR-10 but adopted some reasonable assumptions. The refueling process was emulated by utilizing the fuel loading scenario of the once through then out (OTTO) in combination with the layer-mixed-shell fuel movement. Additionally, the layer-mixed-shell fuel movement considered the concept of fuel channels, where the fuel pebbles only move in the same fuel channel, such that the burnup characteristics of fuel pebbles in both radial and axial direction can be identified separately. The core was divided into 9 fuel zones with a fixed volume and 3 fuel channels with a variety of fuel zones. Furthermore, the number of fuel zones in each fuel channel was determined based on the relative residence time of fuel pebbles in the core. The results revealed that the core can achieve an equilibrium fuel cycle after refueling several times, and after that all the core characteristics can nearly maintain unchanged between different cycles. Although the refueling process was modeled based on the OTTO fuel loading scenario instead of the multi-pass one, the discharged burnup can still reach the target burnup of the spent fuel for HTR-10, i.e. 72 GWd/tHM. In addition, the average discharged burnup under the equilibrium fuel cycle is approximate to 80 GWd/tHM, which also coincides the design value of the spent fuel for HTR-10. Therefore, the layer-mixed-shell movement model can consider the fuel movements in either radial or axial directions simultaneously and enable a more accurate prediction to the real refueling process of HTR-10 than our previous studies.

The effect of burn up on the kinetic parameters for a pressurized water reactor fueled by MOX using MCNPX code

Development of MCBurn and its application in the analysis of SCWR physical characteristics

Neutronic Characterization for a Pressurized Water Reactor Spent Fuel Assembly

Development of Burnup Methods and Capabilities in Monte Carlo Code RMC

Monte Carlo Modeling of Isotopic Changes of Actinides in Nuclear Fuel of APR1400 Pressurized Water Reactor

Burnup computations of online-refueling process for pebble-bed reactors using layer-mixed-shell fuel movement model

Burnup-Dependent Core Neutronics Analysis of Plate-Type Research Reactor Using Deterministic and Stochastic Methods

Review and comparison of neutronic parameters of VVER-1200 and PWR fuel assemblies with different burnable absorbers

ICONE19-43353 DEVELOPMENT AND VALIDATION OF BURNUP FUNCTION IN REACTOR MONTE CARLO RMC

Pressurized Water Reactor Mixed Oxide/UO2 Transient Benchmark Calculations Using Monte Carlo Serpent 2 Code and Open Nodal Core Simulator ADPRES

BEAVRS Full Core Burnup Calculation in Hot Full Power Condition by RMC Code

RMC Capability of Multi-cycle HFP Full Core Burnup Simulation

Neutronic Evaluation of LWR Based SMR with TRU Fuel and Comparison with Different Core Configuration of UO2 and MOX Fuel

Optimization Treatment of Point-Wise Nuclear Data in Monte Carlo Criticality and Burnup Calculations

Research on Coupling Scheme of Monte Carlo Burnup Calculation in RMC

The Effect of Serpent 2 Calculation Parameters on Evaluated Spent Nuclear Fuel Source Term

Steady-state analysis of AP1000 with MOX/UOX mixed core loading

Research on Preventing Xenon Oscillation in Monte Carlo Burnup Calculation Based on RMC

Effect of Pu-rich agglomerates in MOX fuel on reactivity analysis of light water reactor MOX core physics experiments

A simple formula for local burnup based on constant relative reaction rate per nuclei

Analysis of the Effect of Random Errors in Burnup Measurements in a Pebble Bed HTR