Abstract:Recently, various technological light sources have appeared on the market. As a result, it is extremely important to evaluate the characteristics of the available lamps and the impact they may have on the power grid. This article presents regulations and standards for power quality, including higher current and voltage harmonics, and analyzes three selected light-emitting diode lamps. The purpose of the study was to analyze the impact of LED lighting systems on the power quality (PQ) of the electric grid. The results of measurements of parameters determining the power quality of the electricity consumed by modern LED light sources used for room lighting are presented. Commercially available lamps and low-power power supplies (25 to 35 W) with an output current of 350 mA were used for the study. The current waveforms of selected lamps during their connection to the power grid, the results of harmonic emission tests, as well as the effect of increasing the load of selected DC power supplies (drivers) on THD, power factor (PF), and their efficiency are presented. The significant negative impact of power supply circuits in compact LED lamps on the power quality parameters of lighting circuits was demonstrated. The tested lamps significantly exceed the permissible limits of harmonics and THD. Test results have shown that LED lamps show significant savings in electricity consumption, but they behave as nonlinear loads. They generate high-frequency current harmonics, which can lead to degradation of power quality in the distribution network. Therefore, if the primary concern for the user is power quality rather than power savings, traditional incandescent lamps would be a much better choice. When using switched-mode power supplies, attention should be paid to their load rating. You should avoid using power supplies in the lower ranges of permissible load capacity. A more heavily loaded power supply has better performance due to power quality and efficiency.

Experimental Study on Voltage Sag Tolerance of LED Electronic Display

Research on Load Characteristics of Energy-saving Lamp and LED Lamp

Simplified Modeling of the Power-electronized Load Based on Sensitivity Analysis

An Electrolytic-Capacitorless And Inductorless Ac Direct Led Driver With Power Compensation

Steady-State Voltage Stability Analysis Considering the Characteristics of Power Electronic Interfaced Loads

Benchmarking of Voltage Sag Generators

Research on the Effects of Voltage Sags and Harmonics on the Output Characteristics of Switching Power Supply

Design and Implementation of a Series Voltage Sag Compensator under Practical Utility Conditions

Comparison of Detection and Suppression Methods for Voltage Fluctuation and Flicker

Study on LED Reliability in the Aging Process

A quantitative evaluation method of transient voltage stability for large-scale receiving systems and its influencing factors

Evaluation Method and Probabilistic Index of Voltage Sag Severity Considering Point-on-wave

Study on the Characteristics and Compensation of Lamp Voltage Drop

Effect of LED Lighting on Selected Quality Parameters of Electricity

A Novel Voltage Sag Detection Method Based on a Selective Harmonic Extraction Algorithm for Nonideal Grid Conditions

A Fast Voltage Sag Detection Method Based on Second Order Generalized Integrator and Delay Transform Method

Research on Voltage Sag Loss Assessment Based on a Two-Stage Taguchi Quality Perspective Method

A Comprehensive Weight-Based Severity Evaluation Method of Voltage Sag in Distribution Networks

Research on Applicability of the Practical Transient Voltage Stability Criterion Based on Voltage Magnitude and Sag Duration

Industrial Feasibility of Medium-voltage High-power Comprehensive Treatment Device for Voltage Sags

Visual Issues in LED Intelligent Lighting