Effects of Bi and Cu addition on mechanical properties of Sn9Zn alloy and interfacial intermetallic growth with Ni substrate
Haoyang Liu,Yuhang Wei,Ye Zhang,Zhuangzhuang Hou,Xiuchen Zhao
DOI: https://doi.org/10.1016/j.mtcomm.2023.106350
IF: 3.8
2023-06-01
Materials Today Communications
Abstract:Sn9ZnxBixCu (x = 0, 1.0, 2.0, 3.0 and 4.0 wt%) solder alloys were prepared by adding different contents of Bi and Cu elements, and the effects of Bi and Cu addition on the mechanical properties, wettability, and interfacial intermetallic compound (IMC) layer were researched. The addition of Bi and Cu can significantly improve the mechanical properties and creep resistance of the alloy. When the addition of Bi and Cu reaches 2 wt%, small Bi phases are dispersed in the matrix, and moderate Cu5Zn8 phases appear, which strengthens the solder matrix. The ultimate tensile strength (UTS) of the Sn9Zn2Bi2Cu alloy reaches 51.01 MPa, which is 149.32% higher than that of the Sn9Zn alloy, and the elongation reaches 26.56%. Nanoindentation results show that the holding displacement of the Sn9Zn4Bi4Cu alloy decreased by 28.48% compared with that of the Sn9Zn alloy at a loading rate of 0.1 mN/s. In addition, proper addition of Bi and Cu can improve the wettability of the solder alloy and inhibit the growth of interfacial intermetallic compounds (IMCs) between the solder and Ni substrate. When the reflow time reaches 40 min (min), the interfacial IMC thickness of the Sn9Zn2Bi2Cu/Ni solder joint is 1.93 µm, which is 46.09% smaller than that of the Sn9Zn alloy. Moreover, the shear strength of the Sn9Zn2Bi2Cu/Ni solder joint increases by 33.3%, reaching the maximum value (38.76 MPa). When the Bi and Cu addition reaches 2 wt%, the wetting area reaches a larger value (13.525 mm2), which is 28.35% higher than that of Sn9Zn alloy.
materials science, multidisciplinary