Abstract:The ITER poloidal field (PF) coil system provides a magnetic field for plasma shaping and position control together with the central solenoid coils; it needs to operate in a fast pulse mode, leading to induced voltages of up to 14 kV on the coil terminals during operation. The PF magnet system consists of six coils. The cable-in-conduit conductors with niobium-titanium (NbTi) superconducting material are used in the coils. All coils are fabricated by stacking six to nine double pancakes wound by two-in-hand winding scheme. The six PF coils (PF1 to PF6) are attached to the toroidal field coil cases through the flexible plates or sliding supports to allow small radial and vertical displacements. The PF coils will be procured by the European and Russian domestic agencies under separate procurement arrangements. To accelerate the PF6 coil schedule, which is one of the critical paths for the ITER schedule, a cooperation agreement has been placed between F4E and ASIPP in China in October 2013 with the CN-DA support. Before starting the manufacturing of the coil, the component qualification has been started, such as the 3 × 3 conductor mock-up, turn insulation, and helium inlet with the dummy conductors. Corresponding mechanical and electric tests were carried out at room temperature and 77 K. The PF dummy double pancake is also wound to demonstrate the winding. This paper presents the updated design for manufacturing of components. Their fabrication methods are also described. This paper concludes with a summary state report on PF1 dummy winding.

Manufacturing and Fatigue Tests of PF1 Coil Helium Inlet

Fatigue strength of PF-1 coil helium inlet with weld defects.

Structural Analysis and Fatigue Test of Helium Inlet for EAST PF Coil

Test of PF1 Coil Electrical Joint

NDT Status of PF1 Coil Welds

Approaching ITER PF Coil Manufacturing

Completion and Factory Acceptance Test of ITER PF1 Coil

Hot Helium Leak Test of ITER Blanket Shield Block

Mechanical Tests of the ITER's PF-1 Coil Electrical Insulation Qualification Samples at 77 K

Fatigue tests on the ITER PF jacket

Fatigue Behavior Testing and Evaluation of ITER In-vessel Mock-Up Coil under Combined Thermal and Electromagnetic Loads

RADIOGRAPHIC TESTING BY COMPUTED RADIOGRAPHY (RT-CR) OF THE HELIUM INLET WELDS (HI) OF THE POLOIDAL FIELD COIL (PF1), PRODUCED BY JSC NIIEFA (SCIENTIFIC RESEARCH INSTITUTE OF ELECTROPHYSICAL APPARATUS) WITHIN THE FRAMEWORK OF THE INTERNATIONAL THERMONUCLEAR EXPERIMENTAL REACTOR (ITER) PROJECT

Winding Shop of the PF1 Coil Double Pancakes

Manufacturing of Iter Pf5 and Cc Sample Conductors

Manufacture and Acceptance Test of the Full Size ITER PF5 Conductor Sample

Developments of Nondestructive Test Method of Jacket Section for ITER Poloidal Field Coils

Design and Analysis of Full Size Joint Sample for ITER PF Coil

Manufacture and test of seismic bellows for ITER magnet feeder

Delivered Poloidal Field Coils to ITER Fusion Tokamak Facility: Status, Factory Acceptance Test Results and Overview of the Undergone Electrical Tests in Manufacturing Processes