Abstract:Mixed oxides of uranium and plutonium U 1-y Pu y O 2-x are currently studied as reference fuel for Sodium-cooled Fast Reactors (SFRs). To predict the margin to fuel melting, an accurate description of both solidus and liquidus temperatures of these materials is crucial. In this work, after a critical review of the literature data, the parameters of the liquid phase of the CALPHAD models of the Pu–O and U–Pu–O systems are reassessed based on the model of Guéneau et al.. A good agreement between the calculated and selected experimental data is obtained. Using this model, the melting behaviour of U 1-y Pu y O 2±x oxides is then studied as a function of plutonium content and oxygen stoichiometry. The congruent melting for the mixed oxides is found to be shifted towards low O/M ratios compared to the end-members (UO 1.97 and PuO 1.95 ). The temperature of this congruent melting is nearly constant (3130–3140 K) along a ternary phase boundary from UO 1.98 to U 0.55 Pu 0.45 O 1.82 and then decreases with Pu content to a maximum of approximately 3040 K for PuO 1.95. This observation is explained by the stabilisation of the hypo-stoichiometric mixed oxides due to the increase of the configurational entropy at high temperatures by the formation of oxygen vacancies and related cation mixing. The influence of the atmosphere used in the laser heating melting experiments on the oxygen stoichiometry of the sample and its solidus and liquidus temperatures is investigated. The determination of this O/M ratio after laser melting tests using XANES is also reported. The simultaneous presence of U 6+ , U 5+ , U 4+ , Pu 3+ and Pu 4+ is observed, highlighting the occurrence of charge compensation mechanisms. The samples are highly oxidised in air whereas close to stoichiometry (O/M = 2.00) in argon. These results are in agreement with the computed solidification paths. This work illustrates the complex melting behaviour of the U 1-y Pu y O 2±x fuels and highlights the need for the CALPHAD method to accurately describe and predict the high-temperature transitions of the U–Pu–O system.

Molten uranium dioxide structure and dynamics

Plutonium oxide melt structure and covalency

An Adaptive Finite-Element Model For The Behavior Of Uranium Hexafluoride Filled Container In A Fire

Thermophysical Properties of Uo2-Zro2 Melt Measured by Aerodynamic Levitation

High Phonon Scattering Rates Suppress Thermal Conductivity in Hyperstoichiometric Uranium Dioxide

Investigation of the solid/liquid phase transitions in the U–Pu–O system

Evolution of extended defects in UO 2 during high temperature annealing

Polyepitaxial grain matching to study the oxidation of uranium dioxide

Experimental Partitioning of Uranium Between Liquid Iron Sulfide and Liquid Silicate: Implications for Radioactivity in the Earth’s Core

Non-stoichiometric and Subnano-heterogeneous Ln-incorporated UO2: its defect chemistry and thermal oxidation

Capturing the ground state of uranium dioxide from first principles: crystal distortion, magnetic structure, and phonons

Fabrication, defect chemistry and microstructure of Mn-doped UO2

Atomic Simulations of U-Mo under Irradiation: A New Angular Dependent Potential

Molecular dynamics simulation of UO2 nanocrystals melting under isolated and periodic boundary conditions

Potential defect structure effects in the volatility separation of sub-picogram quantities of fission and activation products from an irradiated UO2 matrix

Dissolution kinetics and thermodynamics of uranium from a boltwoodite ore for nuclear fuel cycle application

Interaction between Xe bubbles and grain boundaries as well as the influences on structural evolution in UO2: A molecular dynamics simulation

Microstructural Evolution of Gas Bubbles and Thermal Conductivity in UO2-BeO Bicrystal

Thermal Energy Transport in Oxide Nuclear Fuel

Determination of Thermal Expansion, Defect Formation Energy, and Defect-Induced Strain of α-U Via ab Initio Molecular Dynamics

Differences in coupling between nuclear and electronic energy losses in UO 2 with irradiation temperature: an in situ TEM study