Abstract:ABSTRACT Introduction: Orthodontists have been using clear aligners to treat malocclusions, and one potential effect of treatment with orthodontic aligners is the intrusion and/or resists extrusion of the posterior teeth. This “bite-block effect” is primarily anecdotal due to the frequent occurrence of posterior open bites in patients after clear aligner therapy. Objective: The purpose of this study was to compare changes promoted by clear aligners and traditional fixed appliances in cephalometric measurements of the vertical dimension and molar position in adult patients with Class I malocclusion treated with non-extraction. Methods: Pre- and post-treatment lateral cephalometric radiographs of adult patients treated with either clear aligners (n=44) or traditional fixed appliances (n=22) were selected for retrospective analysis. Eight interval measurements and one nominal measurement were evaluated: anterior overbite (OB), mandibular plane angle related to cranial base (SN_MP) and related to Frankfort (FMA), lower molar height (L6H) and upper molar height (U6H), palatal plane to mandibular plane angle (PP_MP), lower facial height (LFH), total facial height (TFH), and posterior open bite (Posterior_OB). A single evaluator traced all cephalographs, and changes in select measures of the vertical dimension were compared within and between groups. Results: OB decreased (1.15 mm) and L6H increased (0.63 mm) in the traditional fixed appliance group. Mandibular plane angles (related to cranial base and to Frankfort) increased (0.43° and 0.53°, respectively) in the clear aligner group, but just FMA showed significant difference between groups (difference of 0.53°). LFH and TFH increased (ranging from 0.52 mm to 0.80 mm) in both groups, with no differences between treatment modality. Presence of visible posterior open bite significantly increased over the course of treatment. OB, FMA and L6H exhibited an interaction between treatment stage (pre- and post-treatment) and modality (clear aligner therapy and traditional fixed appliances), but no interaction among these three variables was found. Conclusions: The evidence does not support the theory that clear aligner therapy produces better vertical dimension control than traditional fixed appliances. Traditional fixed appliance therapy slightly extruded the lower molar, and clear aligner therapy produced a slightly mandibular backward rotation.

Mandibular incisor inclination and gingival recession after treatment with the Jasper Jumper: a 10-year follow-up

The Stability Guided Multidisciplinary Treatment of Skeletal Class III Malocclusion Involving Impacted Canines and Thin Periodontal Biotype: A Case Report with Eight-Year Follow-Up.

Treatment effects of the MARA appliance and Activator-Headgear combined with fixed appliances in Class II division 1 malocclusion patients: A retrospective longitudinal study

Comparison of the dentoskeletal and soft tissue changes with the cervical headgear and Jones Jig followed by fixed appliances in Class II malocclusion patients: A retrospective study

Morphologic predictors of mandibular changes induced by Sander's Bite Jumping Appliance

Comparative evaluation of a new removable Jasper Jumper functional appliance vs an activator-headgear combination

Treatment Outcome in Angle Class II, Division 1 Patients in Pre-puberty and Puberty after Jumpingthe-Bite Appliance

Treatment Outcome in Angle Class II, Division 1 Patients in Pre-puberty and Puberty after Jumping-the-Bite Appliance

The effect of early intervention on skeletal pattern in Class II malocclusion: A randomized clinical trial

Treatment effects of the Carriere® Motion 3D™ appliance for the correction of Class II malocclusion in adolescents.

Skeletal and dento-alveolar changes obtained with customised and preformed eruption guidance appliances after 1-year treatment in early mixed dentition

Dental Changes and Space Gained As a Result of Early Treatment of Pseudo-Class III Malocclusion.

Three-dimensional cone-beam computed technology evaluation of skeletal and dental changes in growing patients with Class II malocclusion treated with the cervical pull face-bow headgear appliance

Cephalometric evaluation of changes in vertical dimension and molar position in adult non-extraction treatment with clear aligners and traditional fixed appliances

Retrospective comparison of dental and skeletal effects in the treatment of Class II malocclusion between Herbst and Xbow appliances

Treatment Effects of Simple Fixed Appliance and Reverse Headgear in Correction of Anterior Crossbites

Effects of Removable Functional Appliances on the Dentoalveolar Unit in Growing Patients

Differential skeletal and dental effects after orthodontic treatment with bite jumping appliance or activator: a retrospective cephalometric study

Eleven-year stability of a skeletal Class II malocclusion with severe deep overbite and overjet treated with miniscrew-assisted customized lingual appliances: An update

Effects of eruption guidance appliance in the early treatment of Class III malocclusion

The use of tensor analysis to investigate facial changes in treated class II division 1 malocclusions