Abstract:Due to the nonlinear material behavior and contradicting application requirements, the selection of a specific electrical steel grade for a highly efficient electrical machine during its design stage is challenging. With sufficient knowledge of the correlations between material and magnetic properties and capable material models, a material design for specific requirements can be enabled. In this work, the correlations between magnetization behavior, iron loss and the most relevant material parameters for non-oriented electrical steels, i.e., alloying, sheet thickness and grain size, are studied on laboratory-produced iron-based electrical steels of 2.4 and 3.2 wt % silicon. Different final thicknesses and grain sizes for both alloys are obtained by different production parameters to produce a total of 21 final material states, which are characterized by state-of-the-art material characterization methods. The magnetic properties are measured on a single sheet tester, quantified up to 5 kHz and used to parametrize the semi-physical IEM loss model. From the loss parameters, a tailor-made material, marked by its thickness and grain size is deduced. The influence of different steel grades and the chance of tailor-made material design is discussed in the context of an exemplary e-mobility application by performing finite-element electrical machine simulations and post-processing on four of the twenty-one materials and the tailor-made material. It is shown that thicker materials can lead to fewer iron losses if the alloying and grain size are adapted and that the three studied parameters are in fact levers for material design where resources can be saved by a targeted optimization.

Soft magnetic material degradation due to manufacturing process: A comparison of measurements and numerical simulations

Study on Influence of Processing Methods on Loss Coefficients of Iron Loss Model

Loss Analysis of Magnet Eddy Current in a High-Power Density Machine Using a Field-Circuit Coupled Model

Advanced Soft- and Hard-Magnetic Material Models for the Numerical Simulation of Electrical Machines

Incorporating the Soft Magnetic Material Degradation to Numerical Simulations

Measurements of Iron Loss in PMSM Stator Cores Based on CoFe and SiFe Lamination Sheets and Stemmed From Different Manufacturing Processes

Material Design for Low-Loss Non-Oriented Electrical Steel for Energy Efficient Drives

Predicting Iron Losses in Laminated Steel with Given Non-Sinusoidal Waveforms of Flux Density

Modeling of Scalar Dependencies of Soft Magnetic Material Magnetization for Electrical Machine Finite-Element Simulation

Design of a measurement system for investigating the magnetic characteristics of soft magnetic materials for non-sinusoidal periodic excitations

Iron Loss Analysis in Axial Flux Permanent Magnet Synchronous Motors With Soft Magnetic Composite Core Material

Iron Loss Separation in High Frequency Using Numerical Techniques

Fast Iron Loss and Thermal Prediction Method for Power Density and Efficiency Improvement in Switched Reluctance Machines

Calculated versus measured iron losses and instantaneous magnetization power functions of electrical steel

Studies Of High-Frequency Iron Core Loss For Synchronous Electric Machines Used In Electric Vehicles

Modeling of iron losses of permanent-magnet synchronous motors

Impact of a Punching Process on the SyRM Iron Loss: SPICE Model as an Effective Tool for Iron Loss Modeling

Empirical Implementation of the Steinmetz Equation to Compute Eddy Current Loss in Soft Magnetic Composite Components

Iron-Loss Model With Consideration of Minor Loops Applied to FE-Simulations of Electrical Machines

Magnetic Loading of Soft Magnetic Material Selection Implications for Embedded Machines in More Electric Engines