Abstract:Purpose – The purpose of this paper is to present the optimal design of a low-cost interior permanent magnet (IPM) alternating current (AC) motor. It examines the influence of the permanent magnet (PM) materials, and proposes a simple and practical method of optimizing the air-gap field to achieve sinusoidal back electromotive force (EMF), and to reduce the cogging torque. Design/methodology/approach – IPM AC motors with different magnet materials and various topologies are comparatively studied. Finite element method (FEM) is used to predict the performances of these designs. Material costs and manufacture costs are both taken into account. Finally, an optimized design is prototyped and tested, validating the design considerations. Findings – In an IPM AC motor, even if the rotor outer profile is round, the air-gap field distribution can be fined, while the cogging torque can be significantly reduced, by properly shaping the stator tooth tips. Nevertheless, this technique is usually applicable to motor configurations with concentrated windings, but not to those with distributed windings. Originality/value – While using ferrite magnets for PM AC motors with a kW power, interior magnets are usually inserted in V-shaped slots, and the rotor outer profile is often shaped in order to enhance the air-gap field distribution. However, such a rotor configuration usually increases the manufacture costs, and also deteriorates the consistency of mass production. Therefore, a new motor configuration with a round rotor outer profile and shaped stator tooth tips is proposed. It can not only overcome the aforementioned problems, but also improve the motor performance.

Development of a low-cost double rotor axial flux motor with soft magnetic composite and ferrite permanent magnet materials

Design and Fem Analysis of A High Efficiency Axial-Flux Brushless Dc Motor for Flywheel System

Design and Investigation of Flux-Reversal Permanent-Magnet Motor with Less Rare-Earth Magnet for Low-Cost Application

Design Optimization with Outer Rotor Interior Permanent Magnet Synchronous Motor with Hybird Permanent Magnet

Research on a Novel Axial Field Disk Type Switched Reluctance Motor

A Doubly-Fed Variable Flux Reluctance Machine with Integrated Stator Field and Armature Winding and Rotor Armature Winding

Quantitative comparison of low-cost electrical machines with soft magnetic composite and ferrite magnet materials

Design and Analysis of a Novel Dual-PM Flux Reversal Machine for Electric Vehicle Propulsion

New Proposal of 80-Krpm High-Speed Surface-Mounted Permanent-Magnet Synchronous Motor

Design and Analysis of a Transverse-flux Permanent Magnet Motor With Hybrid Iron-core

A Novel Doubly-Fed Flux-Switching Permanent Magnet Machine with Armature Windings Wound on Both Stator Poles and Rotor Teeth

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Comparative Analysis of Doubly Fed Flux-Reversal Permanent Magnet Machines with Different PM Arrangements and Consequent-Pole Topologies

Multi-Objective Optimization Design of a Stator Coreless Multidisc Axial Flux Permanent Magnet Motor

Optimal Design of Low-Cost IPM AC Motor

Design and Analysis of a Permanent Magnet Frameless Motor

Electromagnetic Performance Analysis of Dual-Three-Phase Dual-Rotor Flux-Switching Permanent Magnet Machines

Rare‐earth‐free Al‐Ni‐Co hybrid PMa‐SyRM for an air‐conditioner compressor

Robust Design of a Low-Cost Permanent Magnet Motor with Soft Magnetic Composite Cores Considering the Manufacturing Process and Tolerances

Electromagnetic Optimization of Tangential Rotor for a Low-Speed High-Torque Permanent Magnet Motor

Design and Optimization of Halbach-Array PM Rotor for High-Speed Axial-Flux Permanent Magnet Machine With Ironless Stator