Abstract:The objectives of this study were to investigate the physicochemical dissolution of chrysotile asbestos and to synthesize nano-sized materials and carbonate minerals from the asbestos via acid dissolution and pH changes. Chrysotile asbestos powder was dissolved in 3 different acids, HCl, HThe objectives of this study were to investigate the physicochemical dissolution of chrysotile asbestos and to synthesize nano-sized materials and carbonate minerals from the asbestos via acid dissolution and pH changes. Chrysotile asbestos powder was dissolved in 3 different acids, HCl, H₂SO₄, and HNO₃, and the solutions were then titrated using NH₄OH and reacted with CO₂. The residual material and precipitates were examined with XRD and TEM-EDS. ICP-AES analysis was also used to investigate the chemical makeup of the solution. The concentration of Mg in the solution was about 1,280 mg/L. The chrysotile became noncrystalline silica after acid treatment (pH = 0). At pH 8.6 and 9.5, the precipitates were amorphous iron oxide and nesquehonite [Mg(HCO3)(OH)·2(H₂O)] after reaction with CO₂. The particle size of the precipitates ranged from 2 to 500 nm. These results indicate that dissolution of chrysotile asbestos using HCl, H₂SO4, and HNO3 can chemically alter chrysotile fibers. Also, the dissolved materials can be used as precursors for other materials such as silica, iron oxide, and carbonates. This process may be useful for the synthesis of silica and iron oxides and for mineral carbonation for carbon sequestration. SO4, and HNO₃, and the solutions were then titrated using NH4OH and reacted with CO₂. The residual material and precipitates were examined with XRD and TEM-EDS. ICP-AES analysis was also used to investigate the chemical makeup of the solution. The concentration of Mg in the solution was about 1,280 mg/L. The chrysotile became noncrystalline silica after acid treatment (pH = 0). At pH 8.6 and 9.5, the precipitates were amorphous iron oxide and nesquehonite [Mg(HCO₃)(OH)·2(H₂O)] after reaction with CO₂. The particle size of the precipitates ranged from 2 to 500 nm. These results indicate that dissolution of chrysotile asbestos using HCl, H₂SO₄, and HNO3 can chemically alter chrysotile fibers. Also, the dissolved materials can be used as precursors for other materials such as silica, iron oxide, and carbonates. This process may be useful for the synthesis of silica and iron oxides and for mineral carbonation for carbon sequestration.

Treatment and Destruction of Inorganic Fibers Wastes Like Asbestos by Sodium Polyphosphate

Diopside-Based Glass-Ceramics from Chrysotile Asbestos Tailing

Microwave-assisted acid treatment for the mineral transformation of chrysotile as an alternative for asbestos waste management

Thermal decomposition of different types of asbestos

Mechanochemical conversion of chrysotile/K2HPO4 mixtures into potential sustainable and environmentally friendly slow-release fertilizers

Application of Hazardous Serpentine Rocks’ Extraction Wastes in Composites with Glass Waste and Clay-Sand Mix to Produce Environmentally Clean Construction Materials

Removal of ammonia nitrogen and phosphorus by porous slow-release Ca2+ ceramsite prepared from industrial solid wastes

Efficient Management of Asbestos Waste Through Utilization as Mineral Additives in Portland Cement Production

Treatment of Phosphorus-Containing Raw Materials with Alkaline Solutions

Potential Solidification/stabilization of Clay-Waste Using Green Geopolymer Remediation Technologies

Thermal treatment of carbon-fibre-reinforced polymers (Part 2: Energy recovery and feedstock recycling)

Plasma Vitrification of Air Pollution Control Residues from Municipal Solid-Waste Incineration

Preparation of Calcium Silicate Using Hazardous Solid Wastes and its Application in Treatment of Phosphate-Containing Wastewater

Preparation of eco-friendly porous ceramic with low thermal conductivity by high-temperature treatment of foamed solid waste based geopolymer with cenospheres

High-Temperature Transformation of Asbestos Tailings by Carbothermal Reduction

Waste-derived glass-ceramic LTCC materials prepared from waste soda-lime-silicate glass and waste asbestos wool

Synthesis of foamed glass–ceramics from high‐titanium blast furnace slag using Na3PO4·12H2O as a foam stabilizer

Removal of phosphorus from phosphonate-loaded industrial wastewaters via precipitation/flocculation

Synthesis of Nano-Sized Silicon Oxide, Iron Oxide and Carbonates from Chrysotile Asbestos

Deposition of insoluble calcium phosphate layers by combining finely dispersed calcium hydroxide sols with soluble phosphates

Characterisation of asbestos-containing wastes by thermal analysis