Two-Stage Conversion of Low-Rank Coal or Biomass into Liquid Fuel under Mild Conditions

Xian Li,Dedy Eka Priyanto,Ryuichi Ashida,Kouichi Miura
DOI: https://doi.org/10.1021/ef502574b
2015-04-21
Abstract:The authors have recently proposed a novel degradative solvent extraction method that upgrades and fractionates various types of low-rank coals or biomass wastes into several different molecular weight fractions at around 350 °C. The lowest molecular weight fraction that was recovered as solid (termed soluble) by the yield of 19.4–71.7 wt % on a carbon basis had unique and almost raw-material-independent properties: almost free from ash and moisture, average molecular weight of around 300, carbon content of as high as 81.5–84.8 wt %, and oxygen content of as low as 6.5–12.1 wt %. In this work, the combination of the proposed extraction method and the liquefaction of the soluble under mild conditions was investigated as a two-stage liquefaction method to produce liquid fuel. A rice straw (RS) and a brown coal (LY) were extracted by the proposed extraction method to produce solubles by the yields of 31.5 and 21.7 wt %, respectively. The solubles produced were then liquefied at 400 °C using FeOOH/sulfur as the catalyst under the H2 pressure of as low as 2.0 MPa (at room temperature). Then, 62.1 wt % of RS soluble and 56.8 wt % of LY soluble were converted to the liquid fraction (oil), excluding H2O. The oxygen contents of the oils produced from the two-stage liquefactions of RS and LY were as low as 2.2 and 3.9 wt %, respectively, much lower than those from the direct liquefaction of the raw materials (single-stage liquefaction). Furthermore, both the amount of CO2 emitted and the amount of H2 consumed during the two-stage liquefaction were much less than those of the single-stage liquefaction. Thus, it was shown that combining the degradative solvent extraction method and the liquefaction of the soluble is a promising method to produce high-quality liquid fuel from low-rank coals and/or biomass wastes.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?