Abstract:Impressive improvements in the ability of microfluidic devices to reliably fabricate a wide variety of droplet, capsule, and particle architectures necessitate comparable improvements in techniques to measure and characterize these materials in line. Measurement and control of droplet surface tension are needed to ensure droplet stability while minimizing excess use of surfactants. Standard techniques to measure surface tension typically measure one droplet at a time. Fluidics can be leveraged to measure surface tension in-line with droplet formation. Typically, this requires channel geometries that enable extensional flow. Transient relaxation of deformed droplets is then measured at the exit of a constriction. We propose an alternative approach, in which a single value of steady deformation within a constriction is used to measure surface tension. We flow aqueous droplets in mineral oil through a series of increasingly narrow constrictions and measure steady deformation. In a subset of experiments, droplets contain varying concentrations of polyethylene glycol diacrylate, a common blank-slate hydrogel polymer. We calculate surface tension using Taylor’s small deformation theory, which describes the relationship between steady deformation in shear flows and the Capillary number, the ratio of the applied viscous stress to restoring surface tension stress. We measure surface tension over a wide range of surfactant concentration. Validation using both the transient deformation fluidic approach and pendant droplet measurements demonstrates the viability of our approach. Importantly, our results suggest that steady state measurements of deformation in pressure driven flows provide accurate assessments of surface tension, even when droplets are slightly confined. The use of multiple constrictions allows measurement of hundreds of droplets at several distinct shear rates without the need to vary control parameters. This steady deformation approach represents a readily-accessible option for measuring surface tension of micro-scale droplets in pressure driven flow through rectangular channels.

Critical Assessment of the Surface Tension determined by the Maximum Pressure Bubble Method

Estimating Critical Surface Tension from Droplet Spreading Area

Optimized and Refined Apparatus for Measuring Surface Tension with the Bubble-Pressure Method

Proposal and applicability of a method to evaluate surface tension of liquid using large volume sessile drop in gravity

Finite size effects and optimization of the calculation of the surface tension in surfactant mixtures at liquid/vapour interfaces

Dynamic surface tension determination with the maximum bubble pressure method

Maximum bubble pressure method: Universal surface age and transport mechanisms in surfactant solutions

Measurement of the dynamic surface tension by the maximum bubble pressure method. IV. Surface tension of aqueous solutions of sodium dodecyl sulfate

Surface Tension of Two Near-Ideal Binary Liquid Mixtures and the Influence of Adjacent Vapors

Method to Measure Surface Tension of Microdroplets Using Standard AFM Cantilever Tips

A comparison of different approaches to compute surface tension contribution in incompressible two-phase flows

A Laminar-Jet-discharging Method for Measuring the Interfacial Tension of Deformable Surfaces

Temperature- and Curvature-Dependent Surface Tensions and Tolman Lengths for Real Fluids: A Mesoscopic Investigation

Surface Tension Effects on the Behavior of Two Rising Bubbles

Comparative study on the maximum-pull and tear-off ring method for the measurement of surface tension

The surface tension of Martini 3 water mixtures

Yield stress and elasticity influence on surface tension measurements

Measuring accurately liquid and tissue surface tension with a compression plate tensiometer

Measuring surface tensions of soft solids with huge contact-angle hysteresis

Droplet deformation in steady fluidic flows enables robust, accessible, high-throughput surface tension measurements