Simulation and optimization of air flow and heat transfer characteristic of truck for live animals
Cai Zhiyu,You Tian,Li Xianting
DOI: https://doi.org/10.11975/j.issn.1002-6819.2016.20.029
2016-01-01
Abstract:With the development of technology and the improvement of life standard, the poultry and rabbit breeding industry becomes prosperous and the transportation volume of live animal is larger and larger. To improve the living environment of animal during transportation, the special truck equipped with air conditioner is developed. However, the unreasonable air distribution is a universal problem in the body of this specific truck, leading to local air temperature too high or too low which causes the low animal survival rate and low vehicle loading capacity. There were some simulations and experiments on the refrigerator car, but few on the animal truck. With the requirement of the market, a truck carrying rabbits is chosen as the research object, which is produced by Kangfei Mobile Systems Company in Jiangsu Province. There are 98 air inlets with the radius of 25 mm installed uniformly on the roof of the truck body, 2 air returning outlets with the radius of 160 mm on the front wall of the truck body and 5 air exhausting outlets with the radius of 60 mm on each side of the truck body. This truck carries 1 170 adult rabbits with the designed inside temperature of 18-30 . How to calculate the flow field and temperat℃ ure field of the existing truck and how to optimize the vent layout to achieve a homogeneous temperature distribution of the truck body are the main work in this research. The air flow and heat transfer condition in the truck body are simulated by the Airpak 3.0, which is used for air flow simulation and developed by the ANSYS. The simulation uses 2 equations to calculate the turbulence flow characteristics. The control equations are the standard k-ε equation, the quality equation and the energy equation. The finite volume method (FVM) is used as the discrete method, the one order difference format is used as the wind difference scheme, and the SIMPLE algorithm is used for iterative computation. The simulation method turns out to be accurate through verification by experiment, with the error of less than 3.5% between the simulated and the test results. The research shows that the short circuit of air flow in the front is a serious problem of the existing truck, causing that most supplying air in the upper front of the truck is exhausted directly through the front outlets at low temperature and thereby the utilization of the cool air is not enough. Influenced by the flow field, the air temperature in the truck is low at the upper front part and high at the lower front part with the large temperature difference of about 15.20 between them. The highest℃temperature in the truck body exceeds 3.20 compared with the design temperature range and nearly 21% of rabbit cages℃suffer from the high air temperature. To solve this problem, the principle of vent layout is proposed, which is setting the exhausting and returning outlets at the high temperature area to improve the utilization of the cool supplying air as soon as possible. The optimal vent layout of the rabbit truck is keeping inlets at the roof, and placing outlets at the lower part of both side and bottom of the truck. After the optimization, the air supplied from the inlets flows a longer distance and is mixed more adequately with the air inside, solving the previous short circuit problem of the flowing. The air temperature distribution in the truck body is investigated to be more homogeneous and the maximum temperature difference is decreased to 12.18 ℃. The air temperature of all the rabbit cages keeps in 21.05-29.20 ℃, satisfying the design well. This work investigates the air flow and temperature distribution of the existing truck, proposes the principle of optimal vent layout and simulates the air temperature distribution of the truck after optimization, and the results are significant for the design and production of the truck carrying rabbits.