Abstract:The numerical simulation of the air flow of the room equipped with the crossflow fan air conditioners has been conducted a lot. However, the simulation of the air flow distribution under the heating mode has always been difficult to match the experimental data well, due to the fact that both the air temperature and the flow are affected by the buoyancy. In addition, very few full-scale simulations were conducted. To precisely predict the air flow and temperature distribution of the room with the crossflow fan air conditioner, a full-scale steady numerical simulation was conducted with the Computational Fluid Dynamics (CFD) package. The full-scale physical model was constructed strictly according to the real settings, including the detailed components of the air-conditioner, such as the crossflow fan and the heat exchangers. The Shear-Stress Transport (SST) k-ω turbulent model was selected to simulate the low Reynold flow near the inner surface of the room, and to simulate the high Reynold and transitional flow near the fan blades of the air-conditioner. The porous medium model was used to simulate the heat exchange fins in the air-conditioner. Furthermore, an experiment under the same condition was also conducted to verify the accuracy of the simulation. Results showed that the simulated supply air flow rate was 537.48 m 3 /h, producing a 4.97% deviation from the experiment result. Meanwhile, the upward movement of the supply air from the outlet of the air-conditioner was observed, leading to higher air temperatures in the upper region of the room. Furthermore, among all 210 measured temperature data points in the room, 149 data points had the deviation within ±5%, and 194 data points had the deviation within ±10%. 9 abnormal data points with greater deviation near the door were detected, which might be resulted from the outdoor cold air leakage through the crack between the door and the floor in the experiment. Conclusively, the full-scale numerical simulation in this study produced an accurate and reliable solution to predict the air temperature distribution in buildings, thus providing a potential method for the design or optimization of the air-conditioners.

Simulation and experiment of temperature field of different refrigerated trucks

Simulation, Experimentation, and Collaborative Analysis of Adjacent Heat Exchange Modules in a Vehicular Cooling System

Numerical Simulation and Experimental Study of Capillary Tubes

Simulation and Experimental Study on Thermal State of Engine Compartment of Commercial Vehicle

Numerical simulation of air flow and heat transfer in air refrigerated containers using clean energy technologies

Comparison of Temperature Difference Measurement Technologies Used in Vehicular Heat Exchangers

Characteristics Analysis of Small Insulated Vans Based on Thermoelectric Cooling

Evaluation of Temperature Uniformity in a Middle-Refrigerated Truck Loaded with Pig Carcasses

Simulation Analysis of Temperature Field and Model of Refrigerated Van Body for Characteristic Fruit

Simulation Study on Temperature Field and Cold Plate Melting of Cold Storage Refrigerator Car

Numerical study of flow and heat transfer on construction machinery detached vehicular cooling system

Numerical Simulation of Influencing Factors to the Thermal Insulation Performance of Cold Chain Shipping Containers and Analysis of Internal Flow Field

Evaluation, Monitoring, and Improving the Airflow and Heat Transfer in a Cold Storage of Foodstuffs, CFD Simulation and Experimental Investigation

LCCP-evaluation of refrigerated food transportation

Optimization of a Localized Air Conditioning System Using Thermoelectric Coolers for Commercial Vehicles

Experiment and simulation research of engine cooling fan in dump truck

Research on Air-Duct Optimization and Temperature Uniformity Analysis of Domestic Frost-Free Refrigerator-Freezer

Modeling and experimental study of air-cooled finned-tube condenser using coupled distribution parameter method and air-side temperature distribution

Numerical and experimental investigation of the flow and heat transfer characteristics for cold storage heat exchanger

Full-scale numerical simulation and experimental validation of the thermal environment under the heating mode in an air-conditioned room