Abstract:Abstract Gypsum, an anisotropic hydrous mineral, localizes strain through dehydration‐induced embrittlement and hydrodynamic lubrication, affecting the deformation in active tectonic settings. Here, we examine the micromechanical status of syn‐ and post‐dehydration gypsum‐phases, crucial for understanding intra‐crystalline deformation. We micro‐indented the (010) planes of natural gypsum crystals from 30 to 140°C at various strain‐rates to track mechanical changes during progressive dehydration and phase transition. Thermogravimetric analyses reveal that gypsum dehydrates between 100 and 140°C following a sigmoidal curve. Micromechanical data show, at 30°C, the mean hardness of gypsum is 2.42 GPa, reducing to 0.5 GPa at 140°C, after complete dehydration. Following the sigmoidal dehydration trend, elastic modulus, fracture toughness, and yield stress likewise drops with progressive dehydration. The Gypsum‐Hemihydrate phase exhibits strain‐rate sensitive elastoplastic deformation between 30 and 110°C, as hardness decreases with increasing strain‐rate. We propose that delamination of the layers and extensive tensile cracking along [010] cause this strain‐rate sensitive behavior, displaying Indentation Size Effect. Dehydrated phases (Hemihydrate and γ‐Anhydrite) are formed as exfoliated pseudomorphic flakes through topotactic transformation along [010] and show two sets of oppositely dipping slip systems. During the late dehydration stage (120–140°C), plastic strain is accommodated by the sliding of these flakes along with inelastic pore compaction, resulting in strain‐rate insensitive plastic deformation of the system.

The dehydration kinetics of gypsum at high pressure and high temperature

The effect of pressure on the kinetics of γ-anhydrite crystallization investigated by diamond anvil cell

In-situ Raman study and phase transition of gypsum under high pressure

In Situ Observation of Gypsum-Anhydrite Transition at High Pressure and High Temperature

In-Situ Raman Spectroscopic Study of Phase Transition at High Temperature and High Pressure.

Dehydration Behavior of FGD Gypsum by Simultaneous TG and DSC Analysis

Über das Hochdruckverhalten von Gips / On the Behaviour of Gypsum under High Pressure

Experimental Study on Physical and Mechanical Properties of Gypsum Rock During High-Temperature Dehydration–Hydration Expansion

Dehydration Pathways of Gypsum and the Rehydration Mechanism of Soluble Anhydrite γ-CaSO4

Insights Into the Micromechanics of Dehydration‐Induced Gypsum to γ‐Anhydrite Phase Transition From Instrumented Microindentation Experiments

Formation of α-Hemihydrate Inside of a Gypsum Crystal during the Dehydration Process

Structural evolution during the dehydration of gypsum materials

Metamorphic reaction rate controlled by fluid pressure not confining pressure: implications of dehydration experiments with gypsum

Ammonium Impacts on Vibrations of Hydroxyl and Lattice of Phengite at High Temperature and High Pressure

Experimental Study on the Electrical Conductivity of Pyroxene Andesite at High Temperature and High Pressure

Research on the Raman Spectra of Gypsum at Pressure of 100~800MPa and Room Temperature

A Dehydroxylation Kinetics Study of Brucite Mg(OH)2 at Elevated Pressure and Temperature

Dehydration of gypsum waste to recyclable anhydrite using a nano-film reservoir under ambient conditions

Crystallization Kinetics of α-Hemihydrate Gypsum Prepared by Hydrothermal Method in Atmospheric Salt Solution Medium

Dehydration characteristics of struvite-K pertaining to magnesium potassium phosphate cement system in non-isothermal condition

Effect of Dehydration on the Electrical Conductivity of Phyllite at High Temperatures and Pressures