Abstract:ABSTRACT The suspension is a very important subsystem of a vehicle as it affects both passenger ride comfort and the handling properties of the vehicle. This paper concentrates on two important aspects of suspension system design. One is the fine tuning of a passive suspension system design through an optimisation study using a virtual suspension system model. The second is the design and testing of an active suspension controller. Both problems are treated here in a computer aided setting using a highly realistic suspension system and a full vehicle model, respectively. INTRODUCTION The main reason for the existence of a suspension system like that shown in Figure 1 can be thought of as isolating the driver and passengers of a vehicle from the vibrations induced by road irregularities. This, however, is not the only reason for the use of a suspension system. According to Bastow and Howard (1993), maintaining contact between the wheels and the road surface is a far more fundamental issue as the vehicle's control and stability depends on it. So, suspension design requires concentration not only on ride comfort but also on handling characteristics. As ride and handling requirements are in conflict with each other, the design of suspension system characteristics like effective stiffness and damping require the determination of a compromise solution. While the well known quarter car model and higher order lumped parameter models used to represent the vehicle's overall suspension system are useful for preliminary work and initial design, suspension design work of any practical use has to take into account the physical details of the suspension system being used (double wishbone or McPherson strut type for example). While academic optimisation studies on suspension design and active suspension controller design can concentrate on the quarter car model (Cole, 2001; Yagiz and Yuksek, 2001), one needs to base these optimisation and controller design studies on a much more accurate model of the vehicle's suspension system to be able to transfer the results to the automotive industry. Fortunately, such accurate models are quite readily implementable in the form of canned multibody dynamics programs like Adams® (Anon., 2001) and Simpack (Kortum) or special purpose vehicle dynamics programs like Vedyna (Anon., 2000). The latter approach is taken in this paper. The suspension systems used are highly realistic models formed in Adams/Car® (Anon., 2001). This paper focuses on optimisation of suspension parameters and ride and handling properties and on implementation of active suspension control using an Adams/Car® suspension model. A first step in a suspension optimisation study is to determine which suspension variables can be varied and their

Efficiency improvement of vehicle active suspension based on multi-objective integrated optimization

Multi-objective and Multi-criteria Decision Optimization of Automobile Suspension Parameters

Parameters optimization of interconnected hydro-pneumatic suspension for road comfort and road-friendliness based on genetic algorithm

A new multi-objective optimization method for full-vehicle suspension systems

Fuzzy logic and proportional integral derivative based multi-objective optimization of active suspension system of a 4×4 in-wheel motor driven electrical vehicle

Multi-objective optimization of the suspension system parameters of a full vehicle model

Enhancing the trade-off between ride comfort and active actuation requirements via an inerter-based passive-active-combined automotive suspension

Vibration Performance Optimization of the Semi-Active Suspension with Fuzzy Control Method

Multi-objective optimization study of vehicle suspension based on minimum time handling and stability

Ride Comfort Optimization via Speed Planning and Preview Semi-Active Suspension Control for Autonomous Vehicles on Uneven Roads

USE OF COMPUTER AIDED METHODS FOR OPTIMISATION IN VEHICLE SUSPENSION DESIGN AND FOR DESIGNING ACTIVE SUSPENSIONS

Multi-objective optimization of active suspension system in electric vehicle with In-Wheel-Motor against the negative electromechanical coupling effects

Active Control of Vehicle Suspension Systems Based on Modal Decomposition Method

SEMI-ACTIVE SUSPENSION DESIGNED BY MULTI CRITERIAL OPRIMIZATION METHOD

Quarter and Full Car Models Optimisation of Passive and Active Suspension System Using Genetic Algorithm

Multi-objective H2/H∞ control of uncertain active suspension systems with interval time-varying delay

Multi-objective optimization of multi-axle heavy duty vehicle ride comfort and handling stability based on analytical target cascading method

Pareto Optimal Solution of Vehicle Suspension Optimization

Study on the coordination control of active suspension employing linear motor based on co-simulation

An approach for multi-objective optimization of vehicle suspension system

Dynamic Performance Analysis of Semiactive Vehicle ISD Suspension Based on the Power-Driven-Damper Strategy