Abstract:A sharp-interface numerical approach is developed for modeling the electrochemical environment in crevices and pits due to galvanic corrosion in aqueous media. The concentration of chemical species and the electrical potential in the crevice or pit solution environment is established using the steady state Nernst–Planck equations along with the assumption of local electroneutrality (LEN). The metal-electrolyte interface fluxes are defined in terms of the cathodic and anodic current densities using Butler–Volmer kinetics. The extended finite element method (XFEM) is employed to discretize the nondimensionalized governing equations of the model and a level set function is used to describe the interface morphology independent of the underlying finite element mesh. Benchmark numerical studies simulating intergranular crevice corrosion in idealized aluminum–magnesium (Al–Mg) alloy microstructures in two dimensions are presented. Simulation results indicate that corrosive dissolution of magnesium is accompanied by an increase in the pH and chloride concentration of the crevice solution environment, which is qualitatively consistent with experimental observations. Even for low current densities the model predicted pH is high enough to cause passivation, which may not be physically accurate; however, this model limitation could be overcome by including the hydrolysis reactions that potentially decrease the pH of the crevice solution environment. Finally, a mesh convergence study is performed to establish the accuracy of the XFEM and a sensitivity study examining the relationship between crevice geometry and species concentrations is presented to demonstrate the robustness of the XFEM formulation in handling complex corrosion interface morphologies.

Enhanced predictive corrosion modeling of crevice evolution at e‐coat defects under cyclic climate conditions

Continuum Damage Modeling and Progressive Failure Analysis of Carbon Fiber/epoxy Composite Pressure Vessel

Development of a finite element model for simulation and prediction of mechanoelectrochemical effect of pipeline corrosion

Corrosion of Steel Embedded in Mortar and Concrete under Different Electrolytic Accelerated Corrosion Methods

Corrosion Development of Carbon Steel Grids and Shear Connectors in Cracked Composite Beams Exposed to Wet-Dry Cycles in Chloride Environment.

Molecular Dynamics Simulation of Reinforcing Steel Corrosion when Subjected to Both Chloride Attack and Mechanical Loading

A finite element based model for prediction of corrosion defect growth on pipelines

A Mathematical Model for Cathodic Delamination of Coated Metal Including a Kinetic pH–Porosity Relationship

Validation of a Galvanic Corrosion Model in a Dynamic Electrolyte Droplet Environment

Finite element modeling of corrosion defect growth and failure pressure prediction of pipelines

Investigation of the LME Susceptibility of Dual Phase Steel with Different Zinc Coatings

Effects of external corrosion defect growth on wall pipeline under internal pressure and various defect sizes with mechano‐electrochemical interaction

Numerical simulations of stone-chipping resistance behaviors of automotive coatings: A CFD-DEM model and a wear prediction method

A microstructure-sensitive electro-chemo-mechanical phase-field model of pitting and stress corrosion cracking

Investigation by numerical modeling of the mechano-electrochemical interaction of circumferentially aligned corrosion defects on pipelines

A partitioned computational framework for damage evolution in stress corrosion cracking utilizing phase‐field

Mechanical-Chemical Coupling Effects on an Environmental Barrier Coating System under High-Temperature Water Vapour Conditions

Progress and opportunities in modelling environmentally assisted cracking

Accelerating FEM-Based Corrosion Predictions Using Machine Learning

Simulation Investigation on Environment-Induced Pitting Corrosion on the Metal Surface

An Extended Finite Element Method Based Approach for Modeling Crevice and Pitting Corrosion