Abstract:The inductance model used in traditional sensorless control methods for switched reluctance machines (SRMs) exhibits high-order harmonics. The precision of the motor may be impacted by the buildup of rotor estimate errors caused by these harmonics. To address this issue, this paper proposes a novel method for SRMs that employs a hybrid algorithm combining an enhanced second-order generalized integrator (SOGI)-based frequency-locked loop (FLL) and an active disturbance rejection control (ADRC)-based phase-locked loop (PLL). This approach involves coordinate transformation and parameter identification to reconstruct the motor inductance model. Rotor position errors are calculated using the unsaturated inductance difference method. In order to enhance the accuracy of motor position estimation, a hybrid algorithm is employed to efficiently filter out harmonic errors and mitigate the tremor effect caused by the rotor position differential algorithm. This hybrid algorithm enables the estimate of the motor's speed and rotor position. A sensorless control simulation model was developed using a 12/8 pole SRM to assess the motor's performance under varying load conditions. Based on the results obtained, it is established that the application of this method can accurately estimate the rotor's position and rotational speed and thus improve the performance of position sensorless control. Ultimately, a prototype system for a switched reluctance motor was created, and the effectiveness and feasibility of the proposed control technique were confirmed through experimental validation. This presents an innovative approach to engineering practice.

Motor speed estimation method based on second order generalized integrator-frequency locked loop

A Speed Estimation Scheme Based on an Improved SOGI-FLL for Speed-Sensorless Control of Induction Motor Drives.

Speed-Sensorless Control of Induction Motors with an Open-Loop Synchronization Method

Speed-Sensorless Control of Induction Motor Drives with a STA-FLL Speed Estimation Scheme

Undesirable Oscillations of Phase Locked Loop-Based Position and Speed Estimator for Sensorless Control

Feedback linearization control research of speed sensorless permanent magnet synchronous motor

Position and Speed Estimation for a Permanent Magnet Synchronous Motor Rotor Using Composite Second Order Generalized Integrator

PLL- and FLL-Based Speed Estimation Schemes for Speed-Sensorless Control of Induction Motor Drives: Review and New Attempts

A Novel Flux Estimator Based on Multiple Second-Order Generalized Integrators and Frequency-Locked Loop for Induction Motor Drives

A Delay-Based Frequency Estimation Scheme for Speed-Sensorless Control of Induction Motors

Speed-Sensorless Control of Induction Motor Drives with A Delay-Based Frequency Estimation Method

Dual Phase-Locked Loop-Based Speed Estimation Scheme for Sensorless Vector Control of Linear Induction Motor Drives

The Study of SRM Sensorless Control Strategy Based on SOGI-FLL and ADRC-PLL Hybrid Algorithm

Low Speed Control of Permanent Magnet Synchronous Motor Based on Instantaneous Speed Estimation

A Full-Speed Sensorless Control Algorithm For Interior Permanent Magnet Synchronous Motor Using Sliding-Mode Observer And Hf Signal Injection

A Rotor Position and Speed Estimation Method Using an Improved Linear Extended State Observer for IPMSM Sensorless Drives

Study of Improved Flux Observer and Speed Identification Based on PLL Controller

A Combined Speed Observer Applied in Sensorless Control at Low Speed

Simplified Second-Order Generalized Integrator - Frequency-Locked Loop

Hybrid FOT2F-FOPD controller for permanent magnet synchronization motor based on ILA optimization with SRF-PLL