Abstract:The nanofluids characterization is of fundamental importance to predict their applicability in a real heat transfer situation. In addition to the transport properties, the nanofluid stability is an important factor to be studied, due to the long pumping, heating, cooling and resting cycles the fluids are usually subjected to. Carbon nanotubes have great potential to be used in nanofluids, due to their high thermal conductivity and low density. However, for aqueous medium, stability requires the use of stabilization methods. This work carried out the study of the transport properties and stability of nanofluids with multiwalled carbon nanotubes (MWCNT), using three stabilization methods: Triton X-100 (TrX–MWCNT) and Arabic gum (AG–MWCNT) as surfactants and functionalized carbon nanotubes with COOH group (COOH–MWCNT). These three nanofluids were compared to investigate the best configuration for heat transfer processes. The thermal conductivity was studied using the hot wire method; rheology was studied through three curves in rotational rheometer of concentric cylinders; specific heat was studied by the differential scanning calorimetry method; density was measured by the Coriolis Effect method; nanoparticles size and zeta potential were measured by the dynamic light scattering method. The COOH–MWCNT nanofluids present the highest thermal conductivity increase reaching 15% at 60 °C and 12% at 30 °C with 1wt% while the A.G–MWCNT and TrX–MWCNT reach 11% and 7.5%, respectively, at 30 °C. A.G–MWCNT nanofluids showed greater stability after long sonication times, while COOH–MWCNT presents best dispersion at 0.125 and 0.25 wt%, from 40 to 160 min of sonication. The specific heat increases with temperature and decreases with MWCNT concentration; however, it presents a peculiar increase in the concentration of 0.25 wt%, increasing about 0.5% and 4.5% for A.G–MWCNT and COOH–MWCNT, respectively at 60 °C. COOH–MWCNT nanofluids showed a thixotropic behavior for 0.5 and 1.0 wt% and large viscosity increase reaching 3.75 and 5.5 times the base fluid viscosity at 5 °C and 60 °C, respectively, with 1 wt%. The nanofluids A.G–MWCNT and COOH–MWCNT present good stability, as well as an increase in transport properties, optimized at a concentration close to 0.25 wt% and the COOH–MWCNT nanofluids can be stabilized simply by changing the water pH.

The Specific Heat Capacity, Effective Thermal Conductivity, Density, and Viscosity of Coolants Containing Carboxylic Acid Functionalized Multi-Walled Carbon Nanotubes

Thermo-physical properties of water-based single-walled carbon nanotube nanofluid as advanced coolant

Experimental Investigation and Modelling on the Thermal Conductivity of CNTs Based Nanofluids

Experimental study on the thermal conductivity enhancement of water based nanofluids using different types of carbon nanotubes

An Experimental Determination of Temperature-Dependent Thermal Conductivity of Cyclohexane-Based Nanofluids

Thermophysical properties, heat transfer and pressure drop of COOH-functionalized multi walled carbon nanotubes/water nanofluids

EFFECTIVE THERMAL CONDUCTIVITY OF CARBON NANOTUBE-BASED NANOFLUIDS AT HIGH TEMPERATURES

Temperature Dependent Thermal Conductivity Increase of Aqueous Nanofluid with Single Walled Carbon Nanotube Inclusion

Why Carbon Nanotubes Improve Aqueous Nanofluid Thermal Conductivity: A Qualitative Model Critical Review

Experimental Study On Thermophysical Properties Of Nanotubes And Nanofluids

Thermal Conductivity Enhancements and Viscosity Properties of Water Based Nanofluid Containing Carbon Nanotubes Decorated with Ag Nanoparticles

Thermal and rheological properties improvement of drilling fluids using functionalized carbon nanotubes

Thermophysical and Electrical Properties of Ethylene Glycol-Based Nanofluids Containing CaCO3

MWCNT and COOH–MWCNT aqueous nanofluids: thermophysical and rheological characterization

Viscosity, thermal conductivity and density of carbon quantum dots nanofluids: an experimental investigation and development of new correlation function and ANN modeling

Covalent vs. Non covalent chemical modification of multiwalled carbon nanotubes based-nanofluids: Stability and thermal conductivity steadiness over temperature

Experimental, Price-Performance and Artificial Neural Network (ANN) Analysis of MWCNT-CuO/ Water-EG (50-50) Nanofluid as a Coolant/Antifreeze Working Fluid

Study on thermal conductivity of water-based nanofluids with hybrid suspensions of CNTs/Al2O3 nanoparticles

Thermal conductivity of carbon-based nanofluids; a theoretical modeling using nano-quantitative structure–property relationships

Effective Thermal Conductivity and Thermal Diffusivity of Nanofluids Containing Spherical and Cylindrical Nanoparticles

Effective thermal conductivity of carbon nanotube-based nanofluid